User Guide
Table Of Contents
- How to Use This Manual
- Introduction
- Conventions
- Contents
- Chapter 1 Scanner Overview
- Chapter 2 How to Scan Documents
- Chapter 3 Configuring the Scan Settings
- Chapter 4 Various Ways to Scan
- Chapter 5 Daily Care
- Chapter 6 Troubleshooting
- 6.1 Troubleshooting
- Scanner cannot be powered ON.
- The power LED goes off.
- Scanning does not start.
- Scanning takes a long time.
- Image quality is poor when scanning pictures/photos in black & white.
- Quality of scanned text or lines is unsatisfactory.
- Images are distorted or not clear.
- Vertical streaks appear on the scanned image.
- The power LED flashes after power-on.
- A shadow appears at the top or the bottom of the scanned image.
- Images scanned in black & white (or in grayscale or color) are dark.
- Automatic page size detection fails.
- 6.2 Before You Contact the Scanner Service Provider
- 6.3 Checking the Product Labels
- 6.1 Troubleshooting
- Chapter 7 Operational Settings
- Appendix
- Glossary
- Index
Index
Contents
Chapter 2 How to Scan Documents
Appendix
Glossary
Introduction
TOP
21
Configuring the
Scan Settings
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
How to Scan
Documents
6 Select a scanner driver.
For some image scanning applications, selection of a scanner driver
may not be needed.
7 Select a scanner.
Make sure to select the scanner model that is connected to the
computer.
For some image scanning applications, selection of a scanner may
not be needed.
8 In the scanner driver's setup dialog box, configure the
scan settings.
For some image scanning applications, the scanner driver's setup
dialog box may not appear.
9 Scan the document with the image scanning application.
ATTENTION
When the scanner is communicating with the computer, for
example during scanning, take note of the following:
z Do not unplug the USB cable.
If the USB cable is unplugged and immediately plugged back
again, it may take about two minutes until the computer
recognizes the scanner.
z Do not perform an operation that causes disconnection of the
communication between the scanner and the computer, such
as logging off the user account.