User Manual Part 6

ManualsBrandsFujitsu Technology Solutions ManualsComputers & Accessoriespersonal computer

System expansions

A26361-K520-Z100-4-7619

Changing the floppy disk drive



Open the system unit (see "Opening the system unit").



Remove the hard disk carrier (see "Installing and removing the hard disk drive").



Pull the data and the power supply

connectors from the floppy disk drive.



Remove the screw (1) and take the drive

out of the system unit (2).



Take the new floppy disk drive out of its

packaging.



Push the drive into the system unit (1), and

fix it with the screw (2).



Plug the data and the power supply

connectors into the floppy disk drive.



Remove the hard disk carrier (see

"Installing and removing the

hard disk

drive").



Close the system unit (see "Assembling

the system unit").

If necessary, you must adapt the entry for the drive in the Setup menu.

Summary of content (4 pages)

PAGE 1
System expansions Changing the floppy disk drive Open the system unit (see "Opening the system unit"). Remove the hard disk carrier (see "Installing and removing the hard disk drive"). 1 Pull the data and the power supply connectors from the floppy disk drive. Remove the screw (1) and take the drive out of the system unit (2). Take the new floppy disk drive out of its packaging. 2 2 Push the drive into the system unit (1), and fix it with the screw (2).
PAGE 2
System expansions Installing and removing the hard disk drive Open the system unit (see "Opening the system unit"). Removing the hard disk carrier 2 3 4 1 Lift the hard disk carrier out of the mounting in the direction of the arrow (1) and (2). Lift the hard disk carrier out of the system unit in the direction of the arrow (3) and (4). Pull the data and power supply connectors from the hard disk drive or the hard disk drives.
PAGE 3
System expansions Installing the second hard disk drive 2 Take the new hard disk drive out of its packaging. Make the required settings (e.g. master/slave, stand alone) on the drives. Slide the hard disk drive into the drive carrier (1). Fasten the drive with the screws (2). 1 2 2 Removing the first hard disk drive Lightly press on the clip (1). Pull the hard disk drive out of the carrier (2). 1 2 1 Fold the plastic bracket in the direction of the arrow (1).
PAGE 4
System expansions Removing the second hard disk drive 1 Remove the screw (1). Make the required settings on the remaining hard disk drive (e.g. stand alone). Pull the hard disk drive out of the carrier (2). 2 1 1 Installing the hard disk carrier 3 2 1 4 Plug the data and the power supply connectors into the hard disk drive or into the hard disk drives. Lift the hard disk carrier into the system unit in the direction shown by the arrow (1) and push it forward until it engages (2).