User's Manual

Since this module is not sold to general end users directly, there is no user

manual. For the details about this module, please refer to the specification

sheet. This module should be installed in the host product according the

installation manual.

The following statements must be described on the user manual of host

device of this module;

Note to users in the United States of America

Caution:

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Declaration of Conformity

This device complies with part 15 of FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference

that may cause undesired operation.

Note to users in the United States of America and Canada

Note to users

It is strictly forbidden to use antenna except designated.

This equipment must not be co-located or operated in conjunction with any

other antenna or transmitter.

[For mobile equipment]

This equipment complies with FCC/IC radiation exposure limits set forth

for an uncontrolled environment and meets the FCC radio frequency (RF)

Exposure Guidelines

and RSS-102 of the IC radio frequency (RF) Exposure

rules

. This equipment has very low levels of RF energy that is deemed to

comply without maximum permissive exposure evaluation (MPE).

PAGE 1
Since this module is not sold to general end users directly, there is no user manual. For the details about this module, please refer to the specification sheet. This module should be installed in the host product according the installation manual.
PAGE 2
[For portable equipment] This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without testing of specific absorption rate(SAR).
PAGE 3
The following information must be indicated on the host device of this module; [for FCC] Contains Transmitter Module FCC ID: SQK-7BLZ20 or Contains FCC ID: SQK-7BLZ20 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.