User's Manual

U
SER
’
S
M
ANUAL
This light device has been tested and found to comply with the limits for
Consumer RF Lighting Device, pursuant to Part 18 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
1. Use only on 120 volt, 60 hertz.
2. Never disassemble or modify - any changes could void the user's authority
to operate this device.
3. Not for use in totally enclosed fixtures.
4. Risk of electric shock - do not use where directly exposed to water.
5. This device is not intended for use with emergency exit fixtures or
emergency exit lights.
6. This product could produce interference when used near a TV, radio,
wireless remote control or maritime safety communications equipment or
other critical navigation or communication equipment operating between
0.45-30 MHz. If interference should occur, move the lamp away from
the appliance a distance of three feet or more. Or, plug the lamp or the
appliance into a different outlet.
7. To prevent burns, do not touch the bulb during operation or immediately
after switching off.
8.
Not for use with dimmers, electronic timer or photocell devices or
occupancy sensor.