User's Manual

ManualsBrandsFuji Xerox ManualsElectronicsLimited Modular Transmitter Approval

Table Of Contents

FUJI XEROX

LEFX

User’s Manual

This manual explains the installation process and a function and

performance of Radio Frequency Identification system (LEFX).

This product doesn't permit a repair and an exchange by the end user.

Please contact our service office or a Fuji Xerox product handling Service

Company when the exchange of the device is necessary due to the trouble

and so on.

Also, please read this manual to the end surely, and use a product properly

before you install LEFX in your machine.

FUJI XEROX CO., LTD.

Introduction

This product uses the radio wave of 125kHz. (Inductive Loop System)

Therefore, this product takes a regulation and/or low such as output of the

RF power by each country and/or self-governing body.

Some cases, the final product (e.g. printer) adapts to the law of each

country, and type approval may be required.

The following shall be kept to use a product for the safety.

A cable and TAG shall use designation accessories.

Do not remodel and/or dismantle this product.

Don't remodel this product because a Fire, Electric shock and Machine

trouble may be caused. Because this product uses a radio wave, law of the

country may punish so remodeling of the product.

Remove a power supply soon if you notice smoke or unusual smell.

Remove a power supply if you notice smoke or unusual smell, because it

short-circuits, and a fire and an electric shock may be caused.

Summary of content (6 pages)

PAGE 1
FUJI XEROX LEFX User’s Manual Introduction This manual explains the installation process and a function and This product uses the radio wave of 125kHz. (Inductive Loop System) performance of Radio Frequency Identification system (LEFX). Therefore, this product takes a regulation and/or low such as output of the This product doesn't permit a repair and an exchange by the end user. RF power by each country and/or self-governing body.
PAGE 2
Don't put wiring and/or other articles on this product. This product builds in the antenna which radiates the radio wave. Notice about the law and the standard Performance may not be able to be maintained when the wire etc. is installed on the product and so on. CE 0682 Don't install this product in the place to have the possibility for a liquid This product applies the European NB certificate where it followed the and other material fall. 99/5/ EEC.
PAGE 3
Outline of the product System Requirement The following condition shall be kept, that use LEFX unit system. Summary - LEFX-C must be used with the LEFX-T. LEFX Unit System is RFID (Radio Frequency Identification) device for an - LEFX must be internally installed in machine. (Printer) Inductive loop coupling. This system has two modules of the Reader/Writer - Supply DC Voltage must be 5V+/- 5% and 3.5V +/- 5%. (LEFX-C) and Tag (LEFX-T).
PAGE 4
Layout of the module Installation of Antenna for Toner cartridge to the Printer Antenna LEFX-A Printer LEFX-C area Installation of Antenna for Drum cartridge to the Printer Instillation example The example used for the toner cartridge sensor of the printer is shown in the following.
PAGE 5
Installation of TAG to the toner cartridge Toner cartridge Tag LEFX-T Installation of TAG to the Drum cartridge Tag Drum cartridge LEFX-T
PAGE 6
The explanation of the test mode It is becoming an outside a company top-secret item about the action method of the radio communication. We disclose it about the communication method after purchase contract completion. FUJI XEROX CO., LTD. 3-7-1 Funai, Iwatsuki-shi, Saitama-ken 339-8509 TEL: +81-48-798-5111 URL:http://www.fujixerox.co.