User's Manual



www.frsky‐rc.com

05/09/13



InstructionManualforFrSky2.4GRADIOSYSTEMXJTModule

Introduction

ThankyouforpurchasingFrSky2.4GRADIOSYSTEMXJTmodule. Inordertofullyenjoythebenefitsofthissystem,please

readtheinstructionmanualcarefullyandsetupthedeviceasdescribedbelow.

Overview



Specifications

OperatingVoltageRange:6~15V

OperatingCurrent:140mA@6V

OutputPower:≤100mW

ModuleSlot:JR/GraupnerType

Modulations:PXXorCPPM(auto‐detected)

Modes:D8,D16orLR12(selectable)

TelemetryInterface:SmartPort,RS232SerialPort

UpgradeInterface:SmartPort,RS232SerialPort

What’sNew!

 Twoauto‐detectedmodulationsofPXX(modeselection,bind,modelmatch,rangecheck,failsafe,etc.onradioside)

orCPPM.

 ThreeselectablemodesofD8(existing8chtwo‐way),D16(new16chtwo‐wayfullduplextransmission)andLR12

(new12chone‐waylongrange).

 SmartPortenabled,

realizingtwo‐wayfullduplextransmission.

 Detectthemoduleantenna’sworkingstatusandgivesoundwarningsifthemoduleantennaisbrokenordoesnot

haveintactcontact,etc.

 Superlowerlatency(approx.1/3ofcurrentsystems)andhigherprecision(transmitter’shardwareandsoftware

supportrequired,suchasFrSkytransmitters).



PAGE 1
www.frsky‐rc.com 05/09/13 Instruction Manual for FrSky 2.4G RADIO SYSTEM XJT Module Introduction Thank you for purchasing FrSky 2.4G RADIO SYSTEM XJT module. In order to fully enjoy the benefits of this system, please read the instruction manual carefully and set up the device as described below.
PAGE 2
www.frsky‐rc.com 05/09/13 Smart Port (S. Port) is a signal wire full duplex digital transmission interface developed by FrSky Electronic Co., Ltd. All products enabled with Smart Port (including XJT module, X8R receiver, new hub‐less sensors, new Smart Dashboard, etc), serial port user data and other user input/output devices can be connected without limitations for numbers or sequences at a high transmission speed.
PAGE 3
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.