User's Manual



www.frsky‐rc.com

05/02/13



InstructionManualforFrSky2.4GReceiverX8R

Introduction

ThankyouforpurchasingFrSky2.4GReceiverX8R8/16chfullduplextelemetryreceiver.Inordertofullyenjoythe

benefitsofthissystem,pleasereadtheinstructionmanualcarefullyandsetupthedeviceasdescribedbelow.

Overview



Specifications

Dimension:46.3x26.8x13.6mm(LxWxH)

Weight:14g

NumberofChannels:1~8chfromconventionalchanneloutputs,1~16chfromSBUSport

WithRSSIoutput:analogvoltageoutput(0~3.3V)

OperatingVoltageRange:4.0~10V

OperatingCurrent:100mA@5V

OperatingRange:fullrange(>1.5km)

Compatibility:FrSkyXJTmoduleinD16mode

(Switch1isOFF,Switch2isOFF)orD8mode(Switch1isON,Switch2is

OFF),DFT/DJT/DHT/DHT‐UinD_mode

FirmwareUpgradeable

What’sNew!

 Morenumberofchannels:1~8chfromconventionalchanneloutputs,1~16chfromSBUSport

 WithRSSIoutput:analogvoltageoutput(0~3.3V)

 SmartPortenabled,realizingtwo‐wayfullduplextransmission.



BindingProcedure

Bindingistheprocessofuniquelyassociatingaparticularreceivertoatransmittermodule.Atransmittermodulecanbe

boundtomultiplereceivers(nottobeusedsimultaneously).Areceive rcanonlybeboundtoonetransmittermodule.



SmartPort(S.Port)isasignalwirefullduplexdigitaltransmissioninterfacedevelopedbyFrSkyElectronic

Co.,Ltd.AllproductsenabledwithSmartPort(includingXJTmodule,X8Rreceiver,newhub‐lesssensors,newSmart

Dashboard,etc),serialportuserdataandotheruserinput/outputdevicescanbeconnectedwithoutlimitationsfor

numbersorse

uencesatahi

htransmissions

eed.

PAGE 1
www.frsky‐rc.com 05/02/13 Instruction Manual for FrSky 2.4G Receiver X8R Introduction Thank you for purchasing FrSky 2.4G Receiver X8R 8/16ch full duplex telemetry receiver. In order to fully enjoy the benefits of this system, please read the instruction manual carefully and set up the device as described below. Overview Specifications Dimension: 46.3 x 26.8 x 13.
PAGE 2
www.frsky‐rc.com 05/02/13 Follow the steps below to finish the binding procedure. 1. Turn on the transmitter while holding the F/S button on the module (please refer to the module instruction manual for switch positions). Release the button. The RED LED on the XJT module will flash, indicating the transmitter is ready to bind to the receiver. 2. Connect the battery to the receiver while holding the F/S button on the receiver.
PAGE 3
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.