Product Specifications Sheet

Electrolux Major Appliances, NA., 10200 David Taylor Drive, Charlotte, NC 28262
P/N: 242070201
SYSTEM SPECIFICATION AND PERFORMANCE DATA SHEET
PureSource
®
3 Ice & Water Filter System
APPLICATION GUIDELINES / CONDITIONS OF USE
Water Supply Municipal or well applications
Water Temp. Max. 100°F (38°C), Min. 33°F (0.6°C) - For cold water use only
Water Pressure 100 psi (690 kPa) Max. 30 psi (207 kPa) Min., as measured at the valve inlet
Timely cartridge replacement is essential for the product to perform as advertised. Please refer to the Use & Care Guide for general operation and
maintenance requirements. Your refrigerator will have an electronic light on the freezer door dispenser that lights up yellow or displays “ORDER” when
the filter is almost ready for replacement and lights up red or displays “REPLACE” when the filter must be replaced. The indicator button is pressed
for approximately 3-10 seconds to reset after replacing the filter cartridge. Please refer to the Use & Care Guide for complete instructions. Flush new
cartridge for 4 minutes.
PureSource
®
3 Ice & Water Filter System should not be used on water that is microbiologically unsafe or with water of unknown quality without adequate
disinfection before or after the system. System may be used on disinfected waters that may contain filterable cysts.
While testing was performed under standard laboratory conditions, actual performance may vary. High sediment areas may require more frequent filter
cartridge replacement.
PureSource
®
3 Water Filter System will absorb bad tastes and odors in both ice cubes and drinking water.
SYSTEM SPECIFICATIONS
Flow Rate Ice Maker - 3.4 to 4.3 oz (99 - 125 cc) per 6.3 seconds at 60 psi (as measured at valve inlet)
Dispenser - 60 oz per minute (0.5 gpm or 1.9 liters per minute) at 60 psi (as measured at valve inlet)
Capacity 200 gallons (757 liters)
System Construction Filter Housing Assembly - Polypropylene Plastic
Water Storage Tank - Polyethylene Plastic
Tubing - Polyethylene Plastic
Filter Media - Extruded Carbon Block
REPLACEMENT CARTRIDGE INFORMATION
Replacement WF3CB™ cartridges are available through your local Frigidaire dealer or by calling the Customer Assistance Center at 1-800-374-4432.
Please reference installation instructions in the Use & Care Guide for replacing the cartridge and warranty information. Estimated cost for the replacement
filter cartridge kit: Less than $40.00.
PERFORMANCE DATA
MODEL: PureSource
®
3 Use the replacement cartridge listed below.
The PureSource
®
3 system with the WF3CB™ cartridge has been tested according to NSF/ANSI Standard 42/53 for the reduc-
tion of substances listed below. The concentration of the indicated substances in water entering the system was reduced to a
concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standard 42/53.
General test water parameters; pH = 7.5 +/- 0.5 Temp. 20°C +/- 3°C (68°F +/- 5°F) Pressure = 60 psi
Substance Reduction
NSF
Standard
NSF Reduction
Requirements
Influent
Challenge
Concentration
Maximum
Permissible
Product Water
Concentration
Average
Percent
Reduction
Chlorine taste and odor
42 >/= 50% 2.0 ± 10% mg/L n/a 97.40%
Chlorobenzene
53 n/a 2.0 ± 10% mg/L 0.1 mg/L 99.90%
Cysts
53 99.95% Min 50,000/L n/a 99.99%
2,4-D (Herbicide)
53 n/a 0.210 ± 10% mg/L 0.07 mg/L 94.50%
Alachlor
53 n/a 0.04 ± 10% mg/L 0.002 mg/L 97.50%
Atrazine
53 n/a 0.009 ± 10% mg/L 0.003 mg/L 94.00%
Lead
53 n/a 0.15 ± 10% mg/L 0.01 mg/L 99.10%
Mercury
53 n/a 0.006 ± 10% mg/L 0.002 mg/L 80.40%
Lindane
53 n/a 0.002 ± 10% mg/L 0.0002 mg/L 99.00%
O-Dichlorobenzene
53 n/a 1.8 ± 10% mg/L 0.6 mg/L 99.90%
Toxaphene (Pesticide)
53 n/a 0.015 ± 10% mg/L 0.003 mg/L 93.50%
Particulate class I
42 >/= 85%
Min. 10,000
part./mL
>/= 85% 99.90%
Turbidity
53 n/a 11 +/- NTU 0.5 NTU 98.50%
Styrene
53 n/a 2.0 ± 10% 0.1 mg/L 99.90%
Tetrachloroethylene
53 n/a 0.015 ± 10% 0.005 mg/L 99.60%

Summary of content (2 pages)