Installation guide

INSTALLATIONAND SERVICEMUST BEPERFORMEDBY A QUAUNED INSTALLER.
IMPORTANT:SAVEFORLOCALELECTRICALINSPECTOR'SUSE.
READAND SAVETHESEINSTRUCTIONSFORFUTUREREFERENCE.
FORYOUR SAFETY: Do not store or use gasoline or other flammable vapors and Hquids in the
v[dnity of this or any other appliance.
GENERAL iNFORMATION
Tile Warmer Drawer carl be used:
• As a stand alone applian(e
• As a combination Warmer Drawer with a 30" (76 cm) builtqn oven mounted above
IMPORTANT: The warmer drawer must be installed on a surface leveled from left to right, rear to front and the surface
must be capable of supporting 100 pounds (45 Kg).
Warmer Drawer Dimensions
' BI C;DEPTH
i i
10"(25,4cm) 30"(76,2cm) 233/8"(59,4cm)
I I
HEIGHT WIDTH ' DEPTH
Min. 8 3/8"(21,3cm) 281/2" (72,4cm) 24"(61cm)
Max, 8 5/8"(21,9cm)* 283/4" (73cm)
IMPORTANT: The Warmer Drawer runs off a single
phase three-wire 120 volt, 60 hertz, AC only electrical
supply with ground.
Combination Warmer Drawer/
30" (76 cm) Built-in Oven installation
Caution: Two 3" (7,6 crn) wide X 3/
4" (1,9 cm) thick planks have to be
installed and they should be able to
support 200 pounds, (90,7 K,
H* =10-1/8" (25,7 cm) Min. is a @iticai
dimension and must be applied.
£ HEIGHT
10"(25,4cm) 30"(76,2cm) 233/8"(59.4cm)
Note: It is also possible to install this warmer drawer in a
height opening of 91/4" (23.5 cm). Pleaserefer to page 3
for complete instructions.
Printedin Unit_dStat_s
P/N 318201804 (O412) Rev, C
English - pages 1-4
Espafio[ - pBginas 5-8
Frangais - pages 9-12