=====1 and Components GrH_ Assembly BuiLt=In instructions .. 3-4 ............. 5=8 Gas Requirements Leak Testing ................... Lighting Using the Grill .................. Burner Usage Care & Maintenance Troubleshooting READ AND SAVE THESE INSTRUCTIONS 12 the Grill Rotisserie!Side Wsit the Frigidaire Web Site at: http:flwww.frigidaire.com 9-11 Warranty ........... 1 .............. Your Grill ......................... .....
Congratulations on your purchase of a new grill! We at Electrolux Home Products are very proud of our product and we are completely committed to providing you with the best service possible. Your satisfaction is our #1 priority. Questions? 1-800-320-0859 Please read this Use & Care Manual very carefully. It contains valuable information on how to properly maintain your new grill. The We know you'll enjoy your new grill and thank you for choosing our product. We hope you consider us for future purchases.
IMPORTANT SAFETY INFORMATION - Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury. _' - Extreme care should be used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED. - This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids.
8 2 12 3 13 4 10 11 6 1. Roll top grill hood 8. Warming 2. Grilling/Cooking 9. Infrared surface 3. Side Shelf shelf back burner 10. Electronic burner 4. Control knob: back infrared igniter: main, rear infrared burner 11. Cart with door 5. Control knobs: main burners 12. Side Burner 6. Convection vents 13. Control knob: Side Burner 7. Hood Handle NOTE: Cart, side burner and side shelf are not included with the head only units.
Fig. l SIDE SHELF ATTACHMENT 1. Attach the shelf to the left side of grill by inserting the shelf hooks into the slots on the side of the grill and pushing down on the shelf assembly until level with grill. (See Fig. 1) 2. Lock the shelf in place by inserting (2) self tapping screws into shelf. (See Fig. 2) Fig. 2 INTERIOR PARTS INSTALLATION 1. Install the bottom Flavor Grids in the lower cutouts and around the igniters. (See Fig. 3) 2.
SIDE BURNER PARTS ASSEMBLY 1. Attach the side burner shelf to the grill by inserting the shelf hooks into the slots on the side of the grill and pushing down on the shelf assembly until level with the grill. (See Fig, 8) Fig. 8 2. Lock the side burner shelf in place by inserting (2) hex head screws in the side burner. (See Fig. 9) NOTE: A power screwdriver extension is needed to insert screws. 3. Install burner and cap. (See Fig. 10-11) 4. Install grate over burner. (See Fig. 12) Fig. 9 5.
PLANNING AND DESIGN Start by identifying the number and size of components you want to include in your outdoor cooking center. Countertops must be constructed of non-combustible, outdoor-safe materials. Consider outdoor lighting to illuminate after-dark grilling. For assistance in designing and building your outdoor cooking center, contact a landscape architect or general contractor. Review the drawings on the following pages to determine the exact dimensions and items needed for an outdoor cooking center.
, J_ GFI Electrical Outlet ['_'_'_For Rotisserie Motor /_ ii ......... .... ................... ....... [ .............. ............... Note A* (6.5 Amp Min.) ......... ................ ........ ....... 75_, 3/4" ...... 6" Side Cutout View Front %,,, _'_- Open Space i' ii̧ ii Minimum Clearance ,_,,_ To Open Hood 5" 35.5" Max .................. _ 0.
GENERAL INFORMATION Never attach an unregulated gas line to the appliance. cause excessive heat or fire. Connection to an unregulated gas line can Verify the type of gas supply to be used, either Natural Gas (N,G,) or Liquid Propane (L,P.), and make sure the serial plate agrees with that of the supply, Conversion kits are available separately for an additional cost which will enable you to convert your grill from L.P, to N,G, or to convert your grill from N.
L.P. GAS INSTALLATION Frigidaire Gallery Gas Grills that are set to operate with L.P. gas come with a high capacity hose and regulator assembly. (Note: Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Frigidaire). This assembly is designed to connect directly to a standard 20 lb. L.P. cylinder. L.P. Cylinders are not included with the grill. L.P. Cylinders can be purchased separately at an independent dealer.
GENERAL INFORMATION Although all gas connections on the grill are leak tested prior to shipment, a complete gas tightness check must be performed at the installation site due to possible shifting during shipment, installation or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks and immediately check the system if the smell of gas is detected. BEFORE TESTING Do not smoke while leak testing. Extinguish all open flames. Never leak test with an open flame.
BEFORE LIGHTING Important! Before Lighting... Check the gas supply line for cuts, wear or abrasion. Always keep your face and body as far away from the grill as possible when lighting. GRILL BURNER LIGHTING Fig. 15 Lighting the Grill with electronic igniter 1. Make sure all control knobs are in the "OFF" position. 2. Open the gas supply valve located on top of your L.P. tank. ATTENTION: When turning the L.P.
GRILL LOCATION Do not use the grill in garages, breezeways, sheds or any enclosed area. Never operate the grill in enclosed areas as this could lead to a carbon monoxide buildup, which could result in injury or death. Place the grill on a level surface. Avoid moving the grill while it is in operation. NOTE: The grill will operate best if it is not facing directly into the wind.
The grill rotisserie system is designed to cook items from the back using infrared heat. The rotisserie burner is an infrared type which provides intense searing radiant heat. Preferred by chefs over other cooking methods, this intense heat sears in the natural juices and nutrients found in quality cuts of meats. NOTE: The rotisserie spit rod is centered between the grill hood and the burners. It may be necessary to remove the grates and flavor grids when cooking larger portions of meat on the rotisserie.
• ROTISSERIE • LIGHTING Open the lid. Push and turn the control knob for the rotisserie counter clockwise to the "HIGH" position. Wait 5 seconds. Then press and hold the electronic igniter button. You'll hear a snapping sound. If the burner does not light in 4 seconds, turn the control knob to OFF and wait 5 minutes before trying again. Once lit, turn the control knob to the desired setting. (See Fig.
DRIP TRAY The drip tray located below the grill, inside the cart, should be cleaned periodically to prevent heavy buildup of debris. NOTE: Allow the drip tray to cool before attempting to clean. Important: Do not leave the grill outside during inclement weather unless it is covered (cover sold separately). Rain water can collect inside of the grill, the grill cart or the drip tray if left uncovered.
GENERAL TROUBLE SHOOTING You should inspect the burners at least once a year or immediately if any of the following conditions occur: • The smell of gas. • Flames appearing mostly yellow. (some yellow at the tips is OK) • The grill will not get hot enough. • Burners make a snapping noise. • The grill heats unevenly. SPIDER AND INSECT WARNING Spider and insects can nest in the burners of this or any other grill and cause the gas to flow from the front of the burner.
PROBLEM SOLUTION Grill will not light with a matchor lowheatwith dial set to "High" position. • Is your gas supply fully turned on? • If this is an L.P. grill is there gas in your tank ? Check your gas level. • If this is an L.P. grill, shut off gas supply, disconnect gas line at tank, reconnect the line to the tank. • Make sure all the knobs are in the off position, then open the gas supply valve on the L.P. tank very slowly 1/4 turn, then open fully (at least two full turns). Check flame height again.
Frigidaire Grills have a limited lifetime warranty on all stainless steel panels, a limited 3 year warranty on stainless steel burners, including labor within one year of the date of purchase; and a limited 1 year warranty on all other parts, labor included. In the U.S.A., your appliance is warranted by Electrolux Home Products North America. We authorize no person to change or add to any of our obligations under this warranty.
