Gas Installation

1
30" GAS RANGE INSTALLATION INSTRUCTIONS
* 30" minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or metal
cabinet; or 24" minimum when bottom of wood or metal cabinet is protected by not less than ¼" ame retardant
millboard covered with not less than no. 28 MSG sheet steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper.
The minimum clearance is 0" for the rear of the range. Follow all dimension requirements provided above to prevent
property damage, potential re hazard, and incorrect countertop and cabinet cuts.
Printed in Canada 318201793 (1208) Rev. C
If the information in this manual is not followed
exactly, a re or explosion may result causing property damage,
personal injury or death.
FOR YOUR SAFETY:
— Do not store or use gasoline or other ammable vapors and
liquids in the vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in
your building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the re department.
— Installation and service must be performed by a qualied
installer, service agency or the gas supplier.
• All appliances can tip.
• Injury to persons
could result.
• Install anti-tip
bracket packed with
your appliance.
• See Installation
Instructions.
Avoid locating cabinet storage space above the
surface burners. The absence of cabinets will
eliminate the chance of cabinets catching on re,
and eliminate the possibility of receiving personal
burns from reaching for the cabinets over aming
surface burners. If cabinet storage is to be provided,
risk can be reduced by installing a range hood that
projects horizontally a minimum of 5" beyond the
bottom of the cabinets.
Note: For appliance installed in the
State of Massachusetts see page 2.
Provide proper fuel type
Before proceeding: Your range is factory preset to
operate on natural gas. If L.P. conversion is needed,
contact your local L.P. Gas provider for assistance.
Contact your product dealer to obtain the correct L.P.
conversion kit.
FOR YOUR SAFETY: Do not store or use gasoline or other ammable vapors
and liquids in the vicinity of this or any other appliance.
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.