Installation & Assembly

ManualsBrandsFrigidaire ManualsAir Conditioners12,000 BTU 115-Volt Window-Mounted Compact Air Conditioner with Remote Control

READ BEFORE INSTALLING UNIT

Compact Window Mounting (10,000~12,000 BTU)

Installation Instructions

Before installing, the top rail must be assembled on the unit.

Top Rail Hardware

Qty.

Top Rail

The top rail on your unit may already be installed. If not,

follow the steps below.

Drill (If pilot holes are needed)

the best way to store unit during winter, or when not

in use.

Mounting Hardware

Qty.

( or Wooden windows)

weather stripping

insulation panel

ruler

(10”X3/4”X1/12”)

window sash seal foam 1

Top Rail

The unit is for window mounting only.

INSTALLATION WARNINGS AND CAUTION

Pay attention to danger and safety notices.

be exposed:

Carefully inspect location where air conditioner will be inst

period of time.

Handle air conditioner with care.

Carefully read the installation manual before beginning.

16120300A04443

Summary of content (5 pages)

PAGE 1
Installation Instructions READ BEFORE INSTALLING UNIT Compact Window Mounting (10,000~12,000 BTU) INSTALLATION WARNINGS AND CAUTION The unit is for window mounting only. Carefully read the installation manual before beginning. Pay attention to danger and safety notices. be exposed: Carefully inspect location where air conditioner will be inst period of time. Handle air conditioner with care. NOTE: Qty. Mounting Hardware 7 2 the best way to store unit during winter, or when not in use.
PAGE 2
How to Install Installation LEFT + RIGHT FILLER PANEL ASSEMBLY NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear of (5/16”). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained! Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper panel for each side.
PAGE 3
How to Install Installation Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail of the unit. FIG. 6B FIG. 6A INSIDE OUTSIDE INSIDE OUTSIDE Wooden Windows Vinyl-Clad Windows Extend the side panels out against the window frame (FIG. 7A for wooden windows), (FIG. 7B for Vinyl-Clad windows). FIG. 7A FIG.
PAGE 4
Installation Measure the width of the inner side curtain with the provided ruler, as shown (FIG. 10). Mark a line on the patterned side of the provided insulation panel according to the measured width, then cut out the insulation panel along the line, as shown (FIG.11). Place the patterned side of the insulation panel to face inside your room, then slide the insulation panel into the frame until the panel goes into the side curtain frame completely.
PAGE 5
Installation 10 FIG. 15A & FIG. 15B). normal use, correct the slope otherwise. FIG. 15A FIG. 15B H H INSIDE OUTSIDE H about Bottom Rail INSIDE OUTSIDE Bottom Rail H1 Wooden Window Vinyl-Clad Window FIG. 16 11 In order to minimize air leaks between the room air conditioner and the window opening, suitable weather stripping(trim the provided weather stripping into suitable size) should be applied in case of any gaps found at the location as indicated by the arrows in Fig. 16.