EVAPORATIVE COOLER/ HEATER use & care Introduction ......................................................... 2 The Controls & Operation ............................... 7 Important Safety Information ....................... 3 Cleaning and Maintenance Attention ....... 10 Features ................................................................ 5 Troubleshooting ................................................ 12 Specifications...................................................... 6 Limited Warranty..
INTRODUCTION Welcome to our family Register Your Frigidaire Product Online Today! Take advantage of all the benefits product registration has to offer: Service and Support Diagnose troubleshooting and service issues faster and more accurately Recall Notifications Stay up-to-date on safety notices, system updates, and recall notifications Special Promotions Opt-in for promotions and offers Registering your product information online is safe & secure and takes less than 2 minutes to complete: newai
INTRODUCTION WARNING Please read all instructions before using this appliance. WARNING Cancer and Reproductive Harm www.P65Warnings.ca.gov. Safety Definitions This is the safety alert symbol. It is used to alert of potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. DANGER DANGER indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
IMPORTANT SAFETY INFORMATION Safety Instructions Do not use on soft surfaces, like a bed, where openings may become blocked. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: • A product with heating function has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
FEATURES 5 1. Fan mode 2. Three fan speeds: high, medium, low 3. Cooling function 4. 1, 2, 4 and 8 hours timing function 5. Heater mode 6. Three heater settings: temperature can be set as low (71°F), medium (84°F) and high (96°F) manually. When the environmental temperature is higher than the temperature set by manual, hot wind status will be transferred to cool wind 7. Two oscillation settings; vertical and horizontal 8. Remote control operation available 9.
SPECIFICATIONS ACCESSORIES Remote Control Operation panel and Display panel Remote control operation panel SPECIFICATIONS MODEL NO: FEC350WH02 RATED VOLTAGE 120V RATED FREQUENCY 60 Hz RATED POWER 1200W NOISE 55≤dB CFM PRODUCT DIMENSIONS 350 9.84” W x 13.00” D x 27.
THE CONTROLS & OPERATION INSTALLATION METHOD The product can be used directly after unpacked (without installation). USAGE OF CONTROL PANEL 1. Where power comes initially, all the LED lights will light for 2s and beep. Then, the machine will enter into standby mode and all buttons will be invalid except “ON/OFF” button. a) Press “ON/OFF” button under standby mode and the machine will beep and enter into working mode.
THE CONTROLS & OPERATION Filling water: For cooling function, please add water into the water tank. Before adding water, please open the water tank lock, take the water tank out and add water in it slowly (Figure 1, 2, 3 and 4): put the water tank to the original location after adding water and lock the water tank lock. Water tank pulled out (Fig. 3) Water tank Locked (Fig. 1) Filling water (Fig. 4) Water tank Unlocked (Fig.
THE CONTROLS & OPERATION Using the remote control: 1. Open the battery cover of the remote control and insert a 3V CR2032 battery. 2. Please point to the receiver when using the remote control. 3. If the battery voltage is low, please open the battery cover as shown in the figure and replace with new battery (CR2032). Please note the positive pole and the negative pole of the battery; then, put on the battery cover. 9 4.
CLEANING AND MAINTENANCE ATTENTION Air filter net and cooling pad assembly cleaning If there is too much dust or dirt on the air filter net, the wind effect will be impacted, therefore, it should be cleaned at least once a month. 1. Take the air filter net out first, then the cooling pad can also be taken out (as shown below). 2. Use cleanser and banister brush to clean the air filter net. 3. Dip the cooling pad into cleanser for several minutes, then rinse and dry it. Water tank cleaning 1.
CLEANING AND MAINTENANCE ATTENTION Maintenance 1. When the product is not used for a long time, remove the power plug, pack the product and prevent dust from entering the body, or else it may cause mechanical damage. 2. Please ensure the cooling pad and air filter net is dry and there is no water in the tank before packing. 11 3. After packaging, it should be stored in a dry and ventilated place. 4. If the product fails, please let an authorized service agent repair it.
TROUBLESHOOTING Let us help you troubleshoot your concern! This section will help you with common issues. If you need us, visit our website, chat with an agent, or call us. We may be able to help you avoid a service visit. If you do need service, we can get that started for you! Problem Possible Causes Solution The unit does not cool. There is insufficient water in the tank. Check the water level in the tank and make sure there is enough water.
LIMITED WARRANTY 13 This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.
welcome home Our home is your home. Visit us if you need help with any of these things: owner support accessories service registration (See your registration card for more information.) newair.