FreeWave W5800-01 RF Module Guide Part Number: LFC0003AA Revision: A Last Updated: 08/20/213
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 26 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: KNYPRW1001EC”.
Industry Canada Statement This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: 1. 2. This device may not cause interference, and This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : 1. 2.
et l'obtention d'une autorisation distincte au Canada. End Product Labeling The final end product must be labeled in a visible area with the following: “Contains IC:2329B-PRW1001EC”. Plaque signalétique du produit final Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante: "Contient des IC: 2329B-PRW1001EC".
Introduction This document describes the applicability of user operation of FreeWave’s W5800-01 RF module to keep compliance with regulatory requirements. Host System This module is intended to be used only with FreeWave’s system products. FreeWave’s system must supply regulated voltage to the module. Antenna Usage This module can only be used with the type of antennas approved to be used with FreeWave’s system.
3. External antenna Use only the antennas that have been approved by the applicant. A non-approved antenna(s) may produce unwanted spurious or excessive RF transmitting power which may lead to the violation of FCC limit and is prohibited. 4. Installation procedure This module must be professionally installed within FreeWave’s host system. This module uses a standard PCI express electrical and data interface. The host in which this module is integrated provides a stable 3.