900 MHz Wireless Transceiver Installation Guide V6.0a FreeWave Technologies, Inc. 1880 South Flatiron Court Boulder, CO 80301 (303) 444-3862 (303) 786-9948 Fax www.freewave.com SPREAD SPECTRUM WIRELESS DATA TRANSCEIVER INSTALLATION GUIDE Copyright © 1995-2009 by FreeWave Technologies, Inc. All rights reserved. Published 2009. LIG0003AD Rev A Version 6.
Spread Spectrum Modem Wireless Data Transceiver Installation Guide This installation guide covers all models of the FreeWave Technologies 900 MHz spread spectrum transceiver sold under FCC ID KNY-42182112519. All transceiver models sold under FCC ID KNY-42182112519 must be installed professionally. This transceiver is only approved for use when installed in devices produced by FreeWave Technologies or third party OEMs approved by FreeWave Technologies.
Spread Spectrum Modem Wireless Data Transceiver Installation Guide UL Notification Model# FGR2 is suitable for use in Class 1, Division 2, Groups A, B, C, and D or nonhazardous locations only.. Input voltage for Model# FGR2 is 6 to 30 volts DC. LIG0003AD Rev A Version 6.
Spread Spectrum Modem Wireless Data Transceiver Installation Guide A. Transceiver installation steps To install the FGR2 series transceivers, follow the basic steps given below. 1. Mount the transceiver to the flat, stable surface using mounting holes in the corners of the transceiver. Transceiver models sold under FCC ID KNY- 42182112519 are to be installed professionally in NEMA enclosures. 2. Install the antenna and connect the antenna feed-line to the transceiver.
Spread Spectrum Modem Wireless Data Transceiver Installation Guide 900MHz Omni-directional Antennas Gain Manufacturer 6dBi 5dBi Antennex Antennex Maxrad Maxrad Mobile Mark Mobile Mark Astron 5.15dBi 2dBi 2dBi 2dBi Manufacturer Model Number FG9026 EB8965C BMEFC8985HD MAX-9053 PSKN3-925S PSTG0-915SE ADP91BM FreeWave Model Number EAN0906NF EAN0905WC EAN0900WC EAN0900SR EAN0900SQ --- WARNING: Any antennas placed outdoors must be properly grounded.
Spread Spectrum Modem Wireless Data Transceiver Installation Guide Table 3 below is similar to the Table 2, but shows the information for the 6 dB Yagi antenna. Table 3: EIRP for 6dB Yagi Antenna Cable loss vs. RF Xmit Power Setting. RF Xmit Power 10 9 8 7 6 1dB 35.00 33.80 32.30 30.40 28.20 Cable Loss 2dB 3dB 34.00 33.00 32.80 31.80 31.30 30.30 29.40 28.40 27.20 26.20 4dB 32.00 30.80 29.30 27.40 25.
Spread Spectrum Modem Wireless Data Transceiver Installation Guide C. Board Level Pin Assignments The board level transceiver uses standard RS232 polarity and voltage levels for all of the RS232 signal lines (DTR, Transmit Data, Receive Data, Carrier Detect, RTS, and Clear to Send). Pin 1: B+ Power input. Pin 2: Interrupt (INT) – Input – A 0 volt level on this pin will switch the radio into setup mode.
