Table of Contents Safety Information SYMBOLS Road operator's manual; To receive the risk of Injury, User must read and understand ‘operator's manual before using this product. when Using this tool. Failure to do 20 may rest In hearing loss. Eye protection: Always wear safely goggles, satiety glasses with skis shields, or ful face Risk of serious personal Ary: Never place hands or any other body parts In the fastener discharge area of the taller.
Safety Information (Continued) 1. Do not nal oh top of another nail. This ball can cause the ball to be deflects and hit someone, race to react anc result Always weer ove protection. Operator and others In the work area should always wear ANS approved sacristy goggles with side shields. Eyo protection Is used to guard against flying fasteners and debris, which may cause severs oye Luminary. 3. Always wear faring protection when sng the tool.
Safety Information (Continued) the air hiss or pul the vey tom bast of and wo aloe. any hose that i death or serious personal Injury. 18. Do not drop or throw the tool. Dropping or throwing the final can result In damage that wil make the tool unusable or unsafe. If the tool has been dropped or thrown, examine the tool closely for bent, cracked or broken parts and air leaks. STOP and repair before using, or serious Injury ‘could occur. 19.
Safety Information (Continued) LOADING THE TOOL 1. Do not load the tool with fasteners when any one of the operating control Is activated. 2 Nova lace a hand o ay part of body In stander WEARABLE PARTS Repair parts can hie ordered from our website: plainclothesman. Warranty (Continued PGP INC.
Warranty (Continued) Warranty Excisions These Warranties do not apply where: ® Ru pairs or alterations have neon made, or attempted, by arctics, and/or the unauthorized use of nor ‘conforming pert or accessories. ® Repairs are revived dus to normal wear and tear: # The All Gun has been abused, misused, Improperly maintained or raindrop, Including: the failure to use ‘clean, dry, regulated compressed alr at the recommended pressure; accidents caused by use of the Freeman Product after partial failure.
AIR INLET: 1/4 Inch NPT WEIGHT: 1.38 b MAXIMUM PRESSURE: 100 pal PRESSURE RANGE: 80 pel 100 psi FASTENER LENGTH RANGE: chinchilla Operation 1 LUBRICATION 2.Tum the tool so the air Inlet Is facing up. Place 2-3 ‘drops of pneumatic fastening tool oll into al Inlet. This tool requires lubrication before using the tool for the first time end before each uss. f an inline roller Do not une detergent Ella, oll additives, or air-tool lis.
Operation (Continued) Push gory einsteinium hoc dive fester: 3 SETTING THE AIR PRESSURE 1. The amount of sir pressure recurred depends on the size of the fasteners and the workplace material 2. Begin testing tho depth of drive by driving a test nal Into the same type of workplace material used for the actual job, 3. Drive a teat fastener with the al pressure set at 6095 pai. Raise or lower the air pressure to find the Comer Peron 1 Job wih result 6.
Recommended hookup (Continued) Troubleshooting 1. Tighton screws. housing and cap. 2. Damage to cap goatskin. 2 Replace cap gets. 1. Slap the cep side of the tool Into Airlessness roughcast. | 1. Al escaping from tool the palm of your hand with enough waist of nose area. 2. Damaged O-Ring. force to rests the internal piston, 2 Replace O-dings. Pallor not setting 1. Nal guide loose. 1. Tighter nose guide. fastener completely. 2 Inadequate air flow to baler. 2 Hack hose, ting, or compressor. 1.