FREEDOM-WEB Ready-to-Assemble Privacy Vinyl Fence INSTALLATION INSTRUCTIONS Read all instructions prior to installing product. Refer to manufacturers safety instructions when operating any tools. To register your product, please visit: freedomproduct.
WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the product or individual. • Check local building codes to determine pool-safe fencing options. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. • DO NOT return the product to the store. For assistance or replacement parts call: 1-800-336-2383.
Mark the fence location using string and line stakes (Fig. 1). 1 Fig. 1 NOTE: Plan gate placement, opening and hardware clearance before installing fencing. 2 Post Location: Fig. 2 Measure the width of the fence panel (X) plus the width of the post (Y). This is the common centerto-center measurement (unless there is a cut-down panel) for post hole location (Fig. 2). X Y Post Installation: Dig first two post holes in diameter based on size chart below* and down to your specified frost line.
When included in kit, place aluminum insert into bottom rail, then insert bottom rail into bottom post route hole of first post only (Fig. 5). Panels with 7" rails and 8x6 panels do not require aluminum inserts. Fig. 5 NOTE: 8x8 panels will use aluminum inserts in the middle rail. 5 Attach U-channels to two end boards (Fig. 6). NOTE: Attach U-Channel to "tongue" side of first board, and "groove" side of last board. U-Channel Fig.
For Lattice Top Panels: Fig. 9 Top Rail a. Place lattice into the middle rail followed by the top rail (Fig. 9). b. Finally, add the completed top assembly into the route holes of the first post (Fig. 10). c. Proceed to Step 8. Middle Rail Lattice Fig. 10 For Closed Top Panels: Fig. 11 Pickets a. Insert pickets into middle rail (Fig 11). b. Guide top rail over picket tops (Fig. 12). c. Finally, add the completed top assembly into the route holes of the first post (Fig. 13). d. Proceed to Step 8.
For Open Top Panels with Pickets: Fig. 14 a. Attach middle rail into left side of post route only then guide rail over boards. Insert top rail into left post route holes of first post only (Fig. 14). b. Insert pickets down through top and middle rail (Fig. 15). NOTE: Scalloped and Arched panels have pickets/ boards that are numbered. Start from left side with the #1 picket/board first. c. Proceed to Step 8. For 3-Rail (8' High) Privacy Panels: Fig. 15 Fig. 16 a.
For Shadowbox Panels: Fig. 19 a. Insert the middle rail into middle post route holes of first post only (Fig. 19). b. Insert the top rail into the first top hole post route then guide over top of boards (Fig. 20) c. Proceed to Step 8. Fig. 20 8 Insert the completed fence panel into the route holes of the second fence post. Plumb and level the post and add concrete according to manufacturers instructions to top of hole (Fig. 21). 9 Apply glue on inside rim of post tops then attach to posts (Fig. 22).
BARRETTE OUTDOOR LIVING 7830 FREEWAY CIRCLE MIDDLEBURG HEIGHTS, OHIO 44130 TEL: (888) 418-4400 WWW.FREEDOM.BARRETTEOUTDOORLIVING.