Installation Sheet

stem

wire

SAFETY WARNING: READ WIRING AND GROUNDING

INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS.

TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW

WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN

OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

ADVERTENCIA DE SEGURIDAD: LEA LAS INSTRUCCIONES DE

ENCENDIDO Y CONEXIÓN A TIERRA (I.S. 18) Y CUALQUIER

DIRECCIÓN ADICIONAL. DESCONECTE LA FUENTE DE

ALIMENTACIÓN DURANTE LA INSTALACIÓN. SI SE REQUIERE

NUEVO CABLEADO, CONSULTE A UN ELECTRICISTA

CALIFICADO O AUTORIDADES LOCALES PARA REQUISITOS

SÉCURITÉ AVERTISSEMENT: LIRE LES INSTRUCTIONS DE

CÂBLAGE ET DE MISE À LA TERRE (I.S. 18) ET TOUTES LES

DIRECTIVES SUPPLÉMENTAIRES. MISE EN PLACE DE

L'ALIMENTATION DURANT L'INSTALLATION. SI NOUVEAU

CÂBLAGE EST NÉCESSAIRE, CONSULTER UN ÉLECTRICIEN

QUALIFIÉ OU DES AUTORITÉS LOCALES POUR LES

H I N K L E Y 3 3 0 0 0 Pin O a k P a r k w a y, A von Lak e, OH 440 1 2 8 00 .4 4 6 . 55 39 / 4 4 0 .6 5 3 . 55 0 0 hinkley.com

stem

30144 / 30146 30144 / 30146 30144 / 30146

PAGE 1
HINKLEY wire 30144 / 30146 30144 / 30146 30144 / 30146 L 1 stem stem SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS. HINKLEY ADVERTENCIA DE SEGURIDAD: LEA LAS INSTRUCCIONES DE ENCENDIDO Y CONEXIÓN A TIERRA (I.S. 18) Y CUALQUIER DIRECCIÓN ADICIONAL.
PAGE 2
HINKLEY Mounting Instructions IS19-SCLL J empezar aquí A D B C D F H E DETAIL 2 L STEMS H 1. To begin installation, first attach mounting strap (A) to junction box using two 8-32 screws (B) NOT PROVIDED. Make sure the head of the ground screw is facing down - see DRAWING 1. 2. Next take threaded tube (C) and thread one hex nut (D) onto end. Now thread end of tube (C) into hanging loop (E) approximately 1/2”. Then tighten hex nut (D) against back of hanging loop to lock thread tube in place. 3.
PAGE 3
HINKLEY Drawing 1 – Flus h M ount M I.S. 18 wiring grounding instructions SAFE TY WARNI NG: READ WIRIN G AND GR OUNDING INSTRUCTIO NS (IS 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSU LT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS Drawin g 2 – Chain Hun g S Drawin g 3 – Post-M ount AVERTIS SEMEN T DE SECURITE: LIRE CABL AGE ET INSTRUCTI ONS DE MISE (IS 18), ET TOUTE AUTRE INSTRUCTION.