S600W User Manual 1
FCC Regulations: zThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. zThis device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
I. Functions and Usage The S600W development Kit is used to debug the Franklin Wireless M600W series module. It is designed by an auxiliary board with Franklin Wireless M600W series module embedded. When the S600W is used, you can connect the module to a PC through a USB cable. When the module works normally, the debugging functions can be implemented. The S600W provides multiple interfaces, such as the Mini-USB port, DC power jack, RF connectors. The S600W can be used to test the performance of the module.
2. Diagram of connecting the S600W and the antenna Figure-3. Diagram of connecting the module and the antenna Table-1. Port definition of RF connectors Port definition S600W 1 WiMAX Main 2 WiMAX Aux Figure -4 Port definition of RF connectors IV.
z z z Connect the devices and set up the test environment according to Figure-2. Then connect the S600W to the PC through a Micro-USB to Type A USB cable.. When performing the wired connection test, connect the E5515C to the RF interface of the S600W.. (For the connection method, see Figure-2 ) When performing the wireless connection test, connect the antennas to the RF interface of the S600W directly. (For the connection method, see Figure-3.) V.
