FRAMERY CONTROL UNIT USER MANUAL
Framey Patamäenkatu 7, 33900 Tampere, Finland Info framery.com GENERAL NOTES PRODUCT IS ONLY FOR FRAMERY PRODUCT USE COPYRIGHT THE INFORMATION CONTAINED HERE IS PROPRIETARY TECHNICAL INFORMATION OF FRAMERY. TRANSMITTING, REPRODUCTION, DISSEMINATION AND EDITING OF THIS DOCUMENT AS WELL AS UTILIZATION OF THE CONTENT ARE FORBIDDEN WITHOUT PERMISSION. Version control: 9.2.2021 v 0.
Contents 1. Preface ............................................................................................................................................ 4 2. Intended use and use conditions .................................................................................................... 4 2.1 Non-conventional use ................................................................................................................... 4 2.2 Ambient conditions for use...................................
1. Preface This instruction manual describes the use of Framery Control Unit. It is exclusively for use in Framery’s phone booths, like Framey One, and other future Framery meeting space products, pods. The user instructions contain the following information: General information about the purpose and content of the instructions Intended use and use conditions Compliance statements with list the FCC rules that are applicable to the transmitter.
• • • • • • 1. This Approval is applicable for a portable device. The antenna installation and operating configurations of this transmitter, including any applicable source-based timeaveraging duty factor, antenna gain and cable loss must satisfy Requirements of 2.1093 for general population/uncontrolled exposures. 2. The EUT is a portable device and may not transmit simultaneously with any other antenna or transmitter without shown to be compliant with requirements on 2.
For this device, OEM integrators must be provided with labelling instructions of finished products. Please refer to KDB784748 D01 v07, section 8. Page 6/7 last two paragraphs: A certified device has the option to use a permanently affixed label, or an electronic label. For a permanently affixed label, the devace must be labeled with an FCC ID - Section 2.926 (see 2.2 Certification (labeling requirements) above).
procedure without a transmitter certified device and a device is added, the host manufacturer is responsible for ensuring that the after the device is installed and operational the host continues to be compliant with the Part 15B unintentional radiator requirements.
IC: 26702-9000456 containing IC: 26702-201906EG21G IC: 26702-9000456 contient IC: 26702-201906EG21G Ceci est disponible dans le menu principal de l'unité de contrôle -> Informations de conformité. Ceci est disponible pour l'utilisateur final lorsque l'unité de contrôle est intégrée au produit fini. Ce guide sur la façon d'accéder aux informations d'étiquetage électronique sur l'unité de contrôle doit être présenté à l'utilisateur final dans le manuel d'utilisation du produit final. 4.
1. Install printed circuit board (5) to display frame (3) using 6 screws (6). 2. Install back frame (7) to display frame (3) with 3 screws (8). To assemble the Control Unit to the host product Framery One follow the guidance below. This information is available on Framery One Installation Instructions.