Instructions / Assembly

200001178, 200001415
200001438, 200001416
200001454, 200001417
200001179, 200001418
RAISED GARDEN BED
YOSEMITE FALLS
Layout your timbers along the borderline and
connect each timber together by inserting the top
of the stake through the bracket loops with the
stake pointing to the sky. This enables you to freely
position your border to get your desired location.
Customer Service: 1800-914-9835 | [e-mail]
© Frame It All. All Rights Reserved.
DESIGN A CONTAINS (DESIGN B):
• Composite timbers 2’ x 24 (36)
• Brackets x 48 (72)
• **Stakes x 24 (36)
• Plugs x 96 (144)
• Caps x 12 (12)
ASSEMBLY INSTRUCTIONS
STEP 1:
Assemble the timbers by sliding one end of timber into channel end
of one of the brackets. Use plugs to cover the holes on both sides to
lock the bracket in place.
Repeat this process on the opposite end of the timber flipping the bracket in the opposite
direction (see image). Repeat for all timbers.
Lastly, add caps to each of the top corner joints to finish off the raise.
HAPPY GARDENING!
How the Joints Work
STEP 2:
Layout the base level of your raised garden in a straight ‘L’ shape, using 12 x 2’ timbers.
Insert stake through the hole of the bracket and into each of the corners to lock all sides
in place. For Design B – REPEAT THIS STEP.
Side view
DESIGN A
Bottom: 1 Level
STEP 3:
For the 2
nd
level, layout the level in a smaller “L” shape, using 8 x 2’ timbers for each levels.
Insert stake through the hole of the bracket and into each of the corners to lock all sides in
place
STEP 4:
For the top level, layout the level in a square shape, using 4 x 2’ timbers for each levels.
Insert stake through the hole of the bracket and into each of the corners to lock all sides in
place
Use plugs (included)
to cover the holes on
both side of timbers
FOR INDOOR & HARD SURFACE:
If you plan to assemble raised bed on a hard surface, use
hacksaw to remove the spike of each stake. Use these cut
down stakes for the base level only of your raised garden.
Trim stake spike with
hacksawfor use indoor
or on hard surfaces
DESIGN B
Bottom: 2 Levels
Top view
**NOTE
Stacking stakes can be used on all levels
and when creating additional levels.
ONLY Stacking Stakes can stack!
Use plugs to
cover the holes
– two plugs are
required per
bracket (1 on
each side)
Use a Cap to
complete the
top level.
Use stacking
stakes for
ground level
frames and
stacking
additional levels.
Use stacking
stake when
creating a
multi-level
Stacking stake fit
into the tops other
Stacking stakes