User's Manual

FOXPRO Systems 609 W. 4
th
Street Lewistown, PA 17044
Phone [phone] FAX [phone]
www.gofoxpro.com
TX-5LR Remote Control Instructions
A local – remote switch is installed on the main unit opposite the charge jack. To select
remote control operation, slide the switch to the up position. The transmitter is housed in
a rugged plastic case, and is powered by a standard 9-volt battery. The keypad has
buttons for selecting the sound to be played, controlling the volume, muting the sound,
and controlling an auxiliary device such as a decoy. The sound number is displayed on a
large backlighted liquid crystal display. This, coupled with glow-in-the-dark keys, allows
for easy operation even in total darkness. The transmitter will auto-off after about 5
seconds in order to conserve battery power.
OPERATION
Place the slide switch on the main unit to the “up” position. Turn on the caller and set the
volume control to allow for the loudest sound desired. If you set this control to half way,
the maximum volume in remote mode will be half volume. If you set this control to
maximum, you will be able to adjust the volume all the way up. As you can see, the
volume control sets a maximum sound level while in remote mode. Because the main
unit enters the remote mode with the sound muted, no sound will be heard. Next, select
the sound you want to play by adjusting the number shown in the display with the “Sound
Up” and “Sound Down” buttons. Compare the number to the sound list on the back of
the transmitter. Once you have the proper number in the display, push the “Send” button.
This will store the number in memory. Note that you must push “Send” before the
transmitter times out and shuts off. If this doesn’t happen, the transmitter will resort to
the last number stored with the “Send” button. Note that this button not only stores the
sound number…it also sends it to the main unit. However, sound is not heard because
the main unit is still in “Mute” mode. To make the selected sound play, push the “Mute”
button for about a half-second. This will latch the unit in a mute disabled mode, and
allow the sound to play. You may now adjust the volume by pressing the volume up or
down buttons. Note that it can take as much as 10 seconds to adjust the volume from one
extreme to the other. To play a different sound, select the appropriate sound number on
the display, then push the “Send” button. To mute the sound, push the mute button again.
The “Aux” button is used to control certain accessories sold or approved by FOXPRO.
Do not connect any device not approved by FOXPRO to the Aux connector on the main
unit.
Page 1 (over)