Assembly Instructions
55
Hardware Installation
3.17. Riser Boards
3.17.1. Removing a Riser Board
Follow these steps to remove a riser board:
1. Remove the top cover from the server. See “3.3.1. Removing a Top Cover” on page 55.
2. Remove the expander assembly. See “Removing a K2V4 Expander Bracket” on page 44.
3. Remove the K2T-QB. See “Removing a K2V4 Card” on page 48.
4. Remove the screws securing the riser board.
5. Flip the riser board and remove the riser board as shown in the following illustration.
)LJXUH 5HPRYLQJD5LVHU%RDUG
3.17.2. Installing a Riser Board
Follow these steps to install a riser board:
1. $QJOHDQGLQVHUWWKHULVHUERDUGLQWRWKHEXWWHUÀ\EUDFNHWDVVKRZQLQWKHIROORZLQJLOOXVWUDWLRQ
2. Flip down the riser board and make sure the holes on the riser board are aligned with the holes
RQWKHEXWWHUÀ\EUDFNHW
3. Secure the riser board with the screws.
)LJXUH ,QVWDOOLQJD5LVHU%RDUG
4. Install the K2T-QB. See “Installing a K2V4 Card” on page 49.
5. Install the expander assembly. See “Installing a K2V4 Expander Bracket” on page 45.
Replace the top cover on the server. See “Installing a Top Cover” on page 11.