Instruction Manual

105g铜版纸单色双面印刷
86*108mm
Install the Batteries
Other Advantages
Hotkeys of Keypad
: Open the calculator
Esc: Same as Esc key function (when the calculator is open, it indicates reset)
1. Power Saving design: when there is
no action for the keypad about 10mins，
it will enter dormant state,just press
any key can active it.
1.Switch to ON position from the
back of the keypad.
2. Long press the “Esc+Enter ” key for
2-3 seconds, the LED1 will flick red,
it indicates the keypad enters the
pairing state.
3. Plug the receiver into the computer's
USB port.
4. LED1 goes out, the keyboard and
receiver are successfully coded,
Now you can use the keyboard normally
+
2. Two AAA alkaline batteries: so
the whole system voltage is 3V.
Step 1: Remove the battery cover back by squeezing it from the
keypad to release it.
Step 2: Put the batteries inside as shown.
Step 3: Recover it.
This wireless keypad uses two AAA alkaline batteries
Fosmon 2.4Ghz Wireless Numeric Keypad 22 Keys
Instruction Manual
CAUTION: To use this device properly,please read the
instruction manual carefully before the usage.
Backspace
EnterEsc
This keypad has two red LED indicator lights.
Press Number 1: End
Press Number 2: Down
Press Number 3: PgDn
Press Number 4: Left
Press Number 6: Right
Press Number 7: Home
Press Number 8: Up
Press Number 9: PgUp
Press Number 0: Ins
Press “ . ”:Del
LED1 LED2
1.Turn the switch to ON position, the LED1 light will go
on and then go out after 3 seconds, then the
keypad enters the Power Saving mode.
2.Long press the “Esc+Enter ” key for 2-3 seconds, the LED1 will
flick red, it indicates the keypad enters the pairing state.
3.When the battery voltage is lower than 2.1V, the LED1 flicks red,
please replace the batteries.
4.When the NumLock function is ON, the LED2 will be bright, then you can input
numbers by pressing the number keys.
5. When the NumLock function is OFF, the LED2 will go out, and all numeric keys will
be not effective,and the following is how the functions keys work:
Tab
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
‐‐
Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐‐Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.