User's Manual

ManualsBrandsFortuna Electronic ManualsElectronicsBluetooth GPS

Table Of Contents

Introduction

Overview

The Fortuna Bluetooth GPS receiver is a Global Position System Receiver with

Bluetooth wireless technology and SirF Xtrac technology. This Bluetooth GPS

receiver allows you to receive GPS data on mobile handheld wirelessly. By sending

GPS position data over Bluetooth, you can position with receiver for the best possible

reception all without wires. The advent of Bluetooth GPS receiver will become the

next level of GPS receivers. The SirF Xtrac technology is GPS software that can

acquire and track lower signals than any other autonomous software solution. This

means that it will enable the device to continue provide positions in places previously

not possible.

The Fortuna Bluetooth GPS receiver integrants Bluetooth module into GPS

device, it shows the high performance, high sensitivity, low power consumption,

easily portable, rechargeable& removable battery function and wireless data

transmission. If you have a Pocket PC or other portable devices enabled with

Bluetooth function, for example Ipaq 3870/3970 and O2 XDA, you can take

advantage of your device’s Bluetooth capability to wirelessly add GPS positing

technology. When you choose suitable navigation software, you can apply to personal,

vehicle tracking, and marine navigation.

If you use this Bluetooth GPS receiver, you will ignore the messy cords and

antenna and add the portability of your pocket PC. In addition, This Bluetooth GPS

receiver can change the exhausted battery to full battery like battery of mobile phone.

Main Features

12 Channels “ All-In-View” Tracking

XT – (SirF Xtrac) and ST – (Standard mode) Switch able (Fortuna Patent

Pending)

Position accuracy of 10 meters 2D RMS

Cold/ Warm/ Hot Start Time: 45/38/8 Seconds

Reacquisition Time: 0.1 seconds

RF connector for external GPS antenna

Support Standard NMEA-0183 at 38400 bps baud rate

Support WAAS / EGNOS auto switch

Compatible with Bluetooth devices with Serial Port Profile (SPP)

Superior Sensitivity for Urban Canyon and Foliage Environment

Small, sleek, and lightweight design easily fits in your hand

Three LED at the top of the device show Bluetooth, GPS and Power Status.

Detachable Lithium-Polymer battery lasts for more than 7.5 hours of use

Summary of content (9 pages)

PAGE 1
Introduction Overview The Fortuna Bluetooth GPS receiver is a Global Position System Receiver with Bluetooth wireless technology and SirF Xtrac technology. This Bluetooth GPS receiver allows you to receive GPS data on mobile handheld wirelessly. By sending GPS position data over Bluetooth, you can position with receiver for the best possible reception all without wires. The advent of Bluetooth GPS receiver will become the next level of GPS receivers.
PAGE 2
On/Off Switch button Dimension: L= 74 mm X W= 41.5mm X H= 30 mm Technical Specifications Electrical Characteristics General Chipset SiRF Star Ile/LP; SiRF Xtrac Frequency L1, 1575.42 MHz C/A code 1.023 MHz chip rate Channels 12 channel all-in-view tracking Antenna Type Built-in Ceramic patch antenna (External antenna optional) Accuracy Position 10 meters, 2D RMS 7 meters 2D RMS, WAAS corrected 1-5 meters, DGPS corrected Velocity 0.
PAGE 3
Sensitivity XT Mode Tracking 16dB-Hz Hot Start 23dB-Hz Warm Start 28dB-Hz Cold Start 32dB-Hz Dynamic Conditions Altitude 18,000 meters (60,000 feet) max. Velocity 515 meters/second ( 1000 knots) max. Acceleration 4g, max. Power Operational Power 3.3 VDC ±10% Input Power 5VDC ± 10% Battery Source rechargeable and removable lithium Polymer battery with 5V DC input charging circuit (1200 mA) Operation Time 7.5 hours continuous operating after full charge Battery Charge time 3 Hours Approx.
PAGE 4
Applications Fortuna GPS Bluetooth receiver is a high performance, low power consumption product. The product applications are as follow.
PAGE 5
Caution 1. When switch between the ST mode and XT mode the user must turn off the BT GPS device. 2. When using XT mode on a high-speed environment some delay will be visible. 3. After the GPS device change to XT or ST mode the unit will automatically switch to cold start.
PAGE 6
BT Setting for PC or NB Before you use GPSmart BT connect with PC or NB, you need to have Bluetooth driver and Bluetooth device for PC or NB. Please turn on Bluetooth function in GPSmart BT. As follow: The follow steps of setting Bluetooth function in PC or NB. (1) Enter in “Bluetooth Configuration” and select “ My Bluetooth Place Neighborhood”. Bluetooth Configuration (2) In “ My Bluetooth Place”, you will see “ Entire Bluetooth Neighborhood”.
PAGE 7
(4) After enter “ GPSmart”, the screen will display “ SPP Slave”. (5) Then, enter “ SPP Slave”, it will display “ Bluetooth Connection Request Detected”. SPP Sl ave Wi ndow (6) It will display “ Bluetooth Connection Request Detected “ window.
PAGE 8
(6) The Bluetooth passkey is “ 0000”, please enter “0000” in Bluetooth Passkey Request. Enter passkey (7) Then, it will display confirm window. (8) It indicates GPSmart BT is connecting.
PAGE 9
Connect Bluetooth (9) You can view signal strength in status of “ SPP Slave”. FCC&CE Compliance Statement The Clip-On Bluetooth GPS complies with Part 15 of FCC limits for Class B (DoC). This device has been shown to be in compliance with and was tested in accordance with the measurement procedures specified in the standards Specification listed above and as indicated in the measurement report number :02E0549-D. This product is for home and office use only.