Installation Manual
OEM/Integrators Installation Manual
Model name: FBLE-2020TI
Features
2.4GHz RF transceiver compatible with Bluetooth® Low Energy 5.1 and earlier LE
Specifications
Single-ended or differential RF interface
Description
The device is a 2.4GHz wireless microcontroller (MCU) supporting Bluetooth® 5.1 Low
Energy and Proprietary 2.4GHz applications. Bluetooth basic rate use GFSK modulation,
where an instantaneous data rate of 1 and 2 Mbit/s are possible.
Important Notice to OEM integrators
1. This module is approved for OEM installation only.
2. This module is approved for operation in FORTINET Network Security Gateway,
models as described in this filing.
3. Additional testing and re-certification will be necessary when the conditions
outlined in this OEM installation manual are not fully satisfied.
4. The host manufacturer is responsible for additional EMI/EMC testing to verify
compliance as a composite system. When testing the host device for compliance with
FCC Part 15 Subpart B/ISED ICES-003, the host manufacturer is required to show
compliance while all the transmitter module(s) are installed and operating. The
modules should be transmitting and the evaluation should confirm that the module's
intentional emissions are compliant (i.e. fundamental and out of band emissions).
The host manufacturer must verify that there are no additional unintentional
emissions other than what is permitted in the rule(s) or emissions are complaint with
the transmitter(s) rule(s).
5. For RF Exposure requirement: The host manufacturer must verify that the module
continues to comply with the RF exposure limits for each host device. Preliminary
assessment is normally required to determine if additional certification for RF
Exposure is needed.
End Product Labeling
When the module is installed in the host device, the FCC/IC ID label must be visible
through a window on the final device or it must be visible when an access panel,
door or cover is easily re-moved. If not, a second label must be placed on the outside
of the final device that contains the following text: “Contains FCC ID: TVE-111T15C”;