Owner's Manual

ManualsBrandsFortin ManualsGPS & car accessoriesFortin EVO-ONE

ALL-IN-ONE DATA INTERFACE

REMOTE STARTER / ALARM

QUICK

INSTALLATION GUIDE

(6-PIN) BYPASS RELAY

(5-PIN) CAN-BUS

(4-PIN) RS-232 DATA-LINK & FLASH-LINK UPDATER PORT

BYPASS PROGRAMMING BUTTON

REMOTE STARTER PROGRAMMING LED

CUT LOOP FOR

AUTOMATIC

TRANSMISSION

MODE.

Red White Blue

Blue

Black

LED Blue CAN ACTIVITY

LED Yellow IGNITION ON

LED Red BYPASS DATA

(+) Foot Brake Black In

750mA

(-) Parking lights Pink Out

750mA (-) Trunk Release / AUX

Yellow/Black Out

(-) Hand Brake Brown/White In

(-) Hood/Door

Pink/Black In

%\SDVVFRQ¿J

Purple/Yellow

%\SDVVFRQ¿J

Green/White

%\SDVVFRQ¿J

Green/Red

%\SDVVFRQ¿J

White/Black Out

%\SDVVFRQ¿J

/W%OXH

Ground Black In

(+) Ignition Pink Out

(+) Starter Yellow Out

Out White

(+) ParkLight/IGN2

/ACC/START

3URJUDPPDEOH2XWSXW

(FUNCTION 2 & 31)

Out 2UDQJH

(+) ACC / IGN2

3URJUDPPDEOH2XWSXW

(FUNCTION 2 & 31)

In Red (+) 12V

In Yellow (+) Bypass Ignition

Out Purple (-) Lock

750mA

Out Purple/White (-) Unlock

750mA

Out Green (-) Ignition

750mA

Out White (-) Start

750mA

Out 2UDQJH (-) Disarm

750mA

Out 2UDQJH%ODFN (-) Horn/Siren

2 Amp

Out 'N%OXH

(-) GWR / Programmable 750mA

In Red/Blue

%\SDVVFRQ¿J

/W%OXH%ODFN

%\SDVVFRQ¿J

750 mA MAXIMUM OUTPUT. Do not exceed the maximum current or permanent damage to the module

will occur that will not be covered under warranty.

(6-PIN) POWER CONNECTOR

(20-PIN) SECONDARY CONNECTOR

(3-PIN) Shock Sensor

(2-PIN) Valet/Programming Button

A20

WIRING / CONNECTION GUIDE

PROGRAMMING REMOTE TRANSMITTER(S)

Black

White

(4-PIN) ANTENNA(4-PIN) DATA-LINK ANTENNA

REMOTE

STARTER

FIRMWARE

VERSION

1. [21]

ET PLUS

The system can learn up to a maxi-

mum of 4 transmitters.

Any transmitters can be stored in

more than 1 memory slot.

When a 5th transmitter is learned

the 1st remote is erased (FIFO).

STEP 1 STEP 2 STEP 3 STEP 4 STEP 5 STEP 6

WITH IGNITION SWITCH

Turn the Ignition

OFF.

Turn the

Ignition ON.

The LED will

turn ON

Press and

release the

brake pedal

four times.

Turn the

Ignition

ON.

WITH VALET SWITCH

Press and hold

the valet switch

until the park-

ing lights turn

ON, the horn/

siren will chirp.

Press and release the valet switch

ve time.

The parking lights will ash and the

horn/siren will chirp each time to

conrm.

Press and re-

lease the brake

pedal once.

The LED

will ash

rapidly.

On each Transmitter press

and release the

button

then press and release the

button. The LED will stop

ashing conrming programming.

Turn the Ignition

OFF to exit

programming.

132 4

EVO-ONEEVO-ONE

DOWNLOAD THE SPECIFIC VEHICLE INSTALLATION

GUIDE, USER GUIDE OR THE LATEST QUICK

INSTALLATION GUIDE AT:

WWW.FORTIN.CA

RF642W

GUIDE # 33021

Summary of content (18 pages)

PAGE 1
EVO-ONE QUICK INSTALLATION GUIDE RF642W ALL-IN-ONE DATA INTERFACE REMOTE STARTER / ALARM WIRING / CONNECTION GUIDE GUIDE # 33021 (20-PIN) SECONDARY CONNECTOR (+) Foot Brake (3-PIN) Shock Sensor A1 Black In (2-PIN) Valet/Programming Button In Yellow (+) Bypass Ignition (-) Lock 750 mA (-) Unlock 750 mA 750 mA (-) Parking lights Pink Out Out Purple 750 mA (-) Trunk Release / AUX Yellow/Black Out Out Purple/White (-) Hand Brake Brown/White In Out Green (-) Ignition 750 mA Out
PAGE 2
FUNCTION PROGRAMMING STEP 1 STEP 2 STEP 3 FMH 2-W Disarm the system (The antenna led must not be flashing, see enter/ exit valet mode p.4). FMH 2 -W STEP 5 MODE MODE MODE MODE MODE MODE X1 FMH 2-W OR Turn the Ignition ON. STEP 4 OR Press and hold the valet switch or the antenna button until the Parking lights turn ON, the horn/siren will chirp. Press and release the valet Press and The LED will switch or the antenna but- release the ton X time for the desired brake-pedflash function.
PAGE 3
FUNCTION FUNCTION MODE 1 MODE 2 MODE 3 MODE 4 MODE 5 MODE 6 21 Start Attempts 2 1 3 — — — 22 — — — — — — — 23 Master RESET RESET all programming options by default. (Retains already programmed remote.) — — — — — 24 — — — — — — — Latch until shutdown 25 Yellow/Black (A13) : Aux1 --> LOCK 0.5 seconds & disarm alarm 0.5 seconds 10 sec latch or until a button is pressed. 20 sec latch or until a button is pressed. 30 sec latch or until a button is pressed.
PAGE 4
EVO-ONE QUICK INSTALLATION GUIDE RF642W ALL-IN-ONE DATA INTERFACE REMOTE STARTER / ALARM READY MODE Manual transmission only supported on vehicles with door trigger available on the CAN network. Make sure that all doors are closed and the transmission is in the NEUTRAL position. While the engine is running. Engage the parking brake. The Parking lights will flash once and then remain on.
PAGE 5
SECURITY SYS TEfV1 ONLY REMOTE CAR STARTER ONLY SECURITY SYSTEM AND REMOTE CAR STARTER AUT~MATIC I MANUAL TRANSMISSION
PAGE 6
TABLE OF CONTENTS INTRODUCTION .............................................................................' .................................................... 2 NOTE ................................................................................................................................................. 2 CAUTION - WARNING .........................•••........ ~·········~·············· .. ·························································· 3 REMOTE-STARTING ................................
PAGE 7
IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO: • ensure that the vehicle is parked in a safe and responsible manner. • ensure that the vehicle is not remotely started indoors {garage, underground parking). • ensure that the vehicle is not remotely started with a passenger inside. • ensure that the gearshift lever is in the NEUTRAL position and the parking brake is engaged on manual transmission in order to avoid accidents upon remote starting.
PAGE 8
Two activation methods are possible, please consult the sa esman or instal er to determ ne wh 9h of these modes applies to your vehicle. There are always safety concerns for a manual transmission vehicle to accidentally start while in gear, Ready Mode alleviates these concerns. The driver must enable Ready Mode in order to Remote-Start the vehicle at a later time. Once Ready Mode is set-up the vehicle can be started/stopped at will, as many times as needed.
PAGE 9
When the vehicle is running with the Remote-Starter, enter the vehicle and proceed with the following steps: STEP 1 Insert the key and turn it to the ignition (ON/Run) position. dJh_Warning: Do not turn the key to the START position when the engine is running. This may damage the ignition system on some vehicles. STEP 2 Step on the brake pedal to disable the Remote-Starter, and put the vehicle in gear. ~REMO&~fiARJER FEATURES Idle Mode allows the vehicle to run without the key in the ignition barrel.
PAGE 10
STEP 7 Exit the vehicle and close all of the doors. The vehicle will continue to run after all the doors are closed. STEP 8 The engine will continue to run until either the remote stop function is pressed. the Remote-Starter runtime expires, the parking brake is disengaged, the brake is pressed, or the hood is opened. If the Remote-Starter is shut down by transmitter it will automatically go in to Ready Mode (if all the doors are closed).
PAGE 11
,)(3 STEP 2 Within 1 0 seconds press (1 second) and release the Valet switch 3 times. LJ STEP 3 Valet mode enabled: The LED is ON Valet mode disabled: The LED is OFF To activate and deactivate Valet Mode using the valet switch proceed with the following steps: o •.o• -" "' ·-•-• " ·-~• ... "' " •.o.• '"' • o " ' ' -'· ''' -" "' .o• ''' ' ' '" o• •o• o• ,,, o•. "' " '-' ·' o•. ·-•-• ._. ,._. "'' ' ' ' •-•· •' ' ' '' ·-•• oo• ·'' o•.· ·"" oo• .o• .,. •" STEP 1 • o•,Y; Oo 'A' ......... .............
PAGE 12
If the Remote-Starter is installed with door locks, you will be able to lock and unlock the vehicle without using the key or OEM key fob. To UNLOCK the doors and DISARM the Alarm: •f ;,;+ ·ot:::r:.::.: .tit:tMMt Press the UNLOCK button. The parking lights will flash twice and the LED will turn OFF to confirm the signal. The Starter-Kill will also deactivate allowing the vehicle to be started with the key. If UNLOCK is pressed again (consecutively) the horn will honk twice ·(if installed) to confirm.
PAGE 13
ALARM By default the Alarm will not send an audible confirmation (horn/siren) after the first signal has been received from the remote transmitter(s). SILENT: Press the LOCK or UNLOCK button ONCE and the park lights will flash, horn/siren will NOT confirm the signal. but the AUDIBLE: Pressing the same button TWICE consecutively (LOCK or UNLOCK) the park lights will flash, and the horn/siren will confirm the signal. The Alarm can be programmed to audibly confirm the signal on the first button press.
PAGE 14
TRANSMITIER RANGE Several factors may affect the operating range of the remote transmitter: • A weak transmitter battery. • The operating environment such as in the city and airports due to radio interference, cell phone towers, etc ... • Several types of metal such as the vehicle itself, other vehicles, the windshields tint lines and large buildings. • The vehicle's shape. Vans generally have poorer range. • The shape of the vehicle's roof and the A-pillars cause considerable radio-frequency deflection.
PAGE 15
REMOTE START I AlARM DIAGNOSTICS lx Normal stop {Brake, Park Brake) Runt e expired or shut down by transmitter No tachometer signal 3x 4x 5x Hood open 6x Over crank threshold (8 seconds) 6x 7x 8x 9x sensor - zone 4 Hood open - zone 5 Trunk open - zone 6 Auxilliary IN -zone 7 Ti It Sensor - zone 8 Ignition - ne 9 Page 11 I 12
PAGE 16
PAGE 17
PAGE 18
Disable the REMOTE STARTER by enabling ~A' FI MODE before working under the hood. I I I IVMtacttvez le DEMARREUR A DISTANCE en activant le MoDE VA' t I ~vant d'entreprendre tout travailsousle capot.