BT ACTIVATION CODE Hi John! Volkswagen Jetta 2016 Outdoor 2° 10° RUNNING ENGINE START Phone not included PHONE APPLICATION USER GUIDE EVO-START-BT ANTENNA : FCC ID:2ACKU-ANTNFCBT / IC:12084A-ANTNFCBT MADE IN CANADA / DOC.
NOTE This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
SUMMARY OF SUPPORTED FUNCTIONS Hi John! Volkswagen Jetta 2016 Outdoor 2° 10° RUNNING ENGINE START • Remote start • Stop the Remote start sequence • Locking doors and trunk * • Opening of the trunk * • Control of the AUX.1: sliding doors, defroster, etc. * • Control of the AUX.2: sliding doors, defroster, etc.
KEY TAKEOVER AFTER REMOTE STARTING * KEY TAKEOVER FOR STANDARD KEY VEHICLE * STEP 1 Do not press the foot brake (the engine will shut down). STEP 2 Insert the key into the ignition and turn to ON position. STEP 3 Press the foot brake. KEY TAKEOVER FOR PUSH-TO-START VEHICLE * UNLOCK the doors with either the OEM remote, the remote-starter remote or the proximity remote *.
REMOTE START DIAGNOSTICS * Parking Light flashes (before starting) : Parking Light flashes (after Shutdown) : Runtime expired or shut down by transmitter 3x Ready mode disabled 3x 4x Valet mode activated 4x No tachometer signal 5x 6x Hood open Fail to start (The LED is on) 5x Hood open * The parking light diagnostics can not be used on some vehicles equipped with automatic lights. UNLOCK NF CA C RD Place the NFC Card in front of the ANTNFC-BT for 1 second to UNLOCK the vehicle doors.
INDUSTRY CANADA USER NOTICE Operation is subject to the following two conditions : (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.
BT CODE D’ACTIVATION Hi John! Volkswagen Jetta 2016 Outdoor 2° APPLICATION ANDROID SUR 10° RUNNING ENGINE START Téléphone non inclus GUIDE UTILISATEUR DE L’APPLICATION TELÉPHONE EVO-START-BT ANTENNE : FCC ID:2ACKU-ANTNFCBT / IC:12084A-ANTNFCBT FAIT AU CANADA / DOC.
REMARQUE Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes :(1) Cet appareil ne doit pas causer d'interférences. (2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l'appareil.
SOMMAIRE DES FONCTIONS SUPPORTÉES • • • • • • • • • • • • Démarrage Arrêt de la séquence de démarrage Verrouillage des portes et de la valise* Ouverture de la valise* Contrôle de l’AUX.1 : portes coulissantes, dégivreur, etc.* Contrôle de l’AUX.2 : portes coulissantes, dégivreur, etc.
PRISE EN CHARGE DE LA CLÉ APRÈS DÉMARRAGE À DISTANCE* PRISE EN CHARGE POUR VÉHICULES AVEC CLÉ STANDARD* ÉTAPE 1 Ne pas appuyer sur la pédale de frein (le moteur s’éteindra). ÉTAPE 2 Insérez la clé dans l’allumage et tournez la clé à la position ON. ÉTAPE 3 Appuyer sur la pédale de frein. PRISE EN CHARGE POUR VÉHICULES AVEC BOUTON POUSSOIR* ÉTAPE DÉVERROUILLEZ les portes avec soit: la télécommande d’origine, la télécomande du démarreur à distance*.
3x DIAGNOSTIQUES DÉMARREUR Diagnostique des feux de Diagnostique des feux stationnement avant de stationnement après démarrage : démarrage : Mode Prêt à démarrer désactivé 1x Arrêt normal 4x Mode valet actif 5x 6x Capot ouvert Échec au démarrage 3x (Le témoin est allumé) *Le diagnostique de feux de stationnement ne peut être utilisé sur certains véhicules équipés de lumières automatiques.
AVIS D’INDUSTRIE CANADA AUX UTILISATEURS Le fonctionnement est sujet aux deux conditions suivantes : (1) cet appareil pourrait ne pas causer d’interférence, et (2) cet appareil devrait accepter n’importe quelle interférence, même celle qui pourrait causer un fonctionnement indésirable à l’appareil.