SECURITY SYSTEM ONLY REMOTE CAR STARTER ONLY SECURITY SYSTEM AND REMOTE CAR STARTER AUTOMATIC / MANUAL TRANSMISSION - 2-WAY REMOTES RM942 User Guide Model : REM942 FCC ID: 2ACKU-RM942 IC: 12084A-RM942 Manufacture : FORTIN Model : ANT900 FCC ID: 2ACKU-ANT900 IC: 12084A-ANT900 Manufacture : FORTIN DESIGNED & ENGINEERED IN CANADA DOC#: 68411 - REV:H 20170629 © 2017 ALL RIGHTS RESERVED
TABLE DES MATIÈRES TABLE TABLE OF OF CONTENTS CONTENTS ......................................................................................................................... 2 INTRODUCTION ................................................................................................................................. 2 CAUTION - WARNING ......................................................................................................................... 3 NOTE .........................................
CAUTION - WARNING IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO: • • • • ensure that the vehicle is parked in a safe and responsible manner. ensure that the vehicle is not remotely started indoors (garage, underground parking). ensure that the vehicle is not remotely started with a passenger inside. ensure that the gearshift lever is in the NEUTRAL position and the parking brake is engaged on manual transmission in order to avoid accidents upon remote starting.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful interferences to services authorized by IC.
+ Press and release FUNCTON and then press simultaneously LOCK and FUNCTON LOCKED THE REMOTE Until the RED DEL turn on. See : REMOTE LOCKING AND UNLOCKING, page 11 UNLOCKED THE REMOTE Until the GREEN DEL turn on. See : REMOTE LOCKING AND UNLOCKING, page 11 The remote BLUE led turn ON when a button is pressed. The remote flash BLUE when the remote is transmitting the informations. The remote GREEN led turn ON when the vehicle succesfully received the command. After 5 sec.
ACCESSORY PRESET Heater & Heated Seat(s): When leaving the vehicle it is recommended that the driver pre-set the climate controls in preparation for a later Remote-Start. When the vehicle RemoteStarts, the current (or last) setting for the climate controls, windshield wipers (and other accessories) will be used. When setting the blower motor (fan speed) and heated seats (if equipped) should not be left on HIGH. It is recommended to leave these settings on either a LOW or MEDIUM setting.
METHOD 2 This method must be programmed by the installer during installation. THIS METHOD WILL ACTIVATE THE REMOTE STARTER SEQUENCE EVERYTIME THE END USER IS LEAVING THE VEHICLE. AUTOMATIC ACTIVATION: The vehicle must be running. STEP 1 Make sure the transmission is in the NEUTRAL position. STEP 2 Engage the parking brake. STEP 3 Release the brake pedal. STEP 4 OFF Remove the key from the ignition barrel. The engine will shut down and the vehicle will be ready to start at any time.
REMOTE-STARTER FEATURES IDLE MODE (AUTOMATIC TRANSMISSION) Idle Mode allows the vehicle to run without the key in the ignition barrel. For example, if you stop for a quick errand or delivery, simply allow the vehicle to run while you are gone. The engine will run until the Remote-Starter runtime expires. Press START any time the vehicle is running with the Remote-Starter to reset this timer.
WARNING : Never leave children or animals in a Remote-Started vehicle unattended. TURBO MODE (AUTOMATIC TRANSMISSION) Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the driver leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing the turbo-charger to cool down.
VALET MODE (VIA REMOTE) Valet Mode disables the remote-starter and alarm. Whenever the vehicle is being serviced or repaired, or the vehicle is parked indoors it is mandatory that Valet Mode be enabled to prevent an accidental Remote-Start. Note: The alarm system is deactivated (including Starter Kill) when the system is in Valet Mode. However you are still able to lock & unlock the doors, and release the rear hatch/trunk.
AUXILIARY USE Aux 1 : Drivers side sliding door (if installed) : Press and relase the FUNCTION (the remote LED flashes slowly white) button within 12 seconds press the button LOCK button.The remote’s Green Led flash and beep once to confirm. Aux 2 : Passenger side sliding door (if installed). Press and relase the FUNCTION button (the remote LED flashes slowly white) within 12 seconds press the UNLOCK button.The remote’s Green Led flash and beep once to confirm.
REMOTE DOOR LOCKS If the Remote-Starter is installed with door locks, you will be able to lock and unlock the vehicle without using the key or OEM key fob. To UNLOCK the doors and DISARM the Alarm: Press the UNLOCK button for 0.5 second. The remote Green Led flash and beep once to confirm. The parking lights will flash twice and the LED will turn OFF to confirm the signal. The Starter-Kill will also deactivate allowing the vehicle to be started with the key.
ALARM AUDIBLE CONFIRMATION By default the Alarm will not send an audible confirmation (horn/siren) after the first signal has been received from the remote transmitter(s). SILENT : Press the LOCK or UNLOCK button ONCE and the park lights will flash, but the horn/siren will NOT confirm the signal. AUDIBLE : Pressing the same button TWICE consecutively (LOCK or UNLOCK) the park lights will flash, and the horn/siren will confirm the signal.
TRANSMITTER RANGE Several factors may affect the operating range of the remote transmitter: • A weak transmitter battery. • The operating environment such as in the city and airports due to radio interference, cell phone towers, etc… • Several types of metal such as the vehicle itself, other vehicles, the windshields tint lines and large buildings. • The vehicle’s shape. Vans generally have poorer range. • The shape of the vehicle’s roof and the A-pillars cause considerable radio-frequency deflection.
REMOTE START / ALARM DIAGNOSTICS REMOTE STARTER DIAGNOSTICS Parking Light flashes (before starting) : 3x Ready mode disabled 4x Valet mode activated (The LED is on) 5x Hood open Parking Light flashes (after Shutdown) : 1x Normal stop (Brake, Park Brake) 3x Runtime expired or shut down by transmitter 4x No tachometer signal 5x Hood open 6x Over crank threshold (8 seconds) Page 15 / 15 ALARM DIAGNOSTICS Parking Light flashes (after disarm) : 3x Door open – zone 3 4x Shock sensor – zone 4 5x Hood open – zon