SECURITY SYSTEM ONLY REMOTE CAR STARTER ONLY SECURITY SYSTEM AND REMOTE CAR STARTER AUTOMATIC / MANUAL TRANSMISSION - 1-WAY REMOTES FTX74-1W User Guide MODEL : FTX74 FCC ID : 2ACKU-R1W03FM IC : 12084A-R1W03FM Manufacture : FORTIN Model : ANT-FMH-2W FCC ID : 2ACKU-A2W01FM IC : 12084A-A2W01FM Manufacture : FORTIN DESIGNED & ENGINEERED IN CANADA DOC#: 68331 - REV:G 20170628 © 2017 ALL RIGHTS RESERVED
TABLE DES MATIÈRES TABLE TABLE OF OF CONTENTS CONTENTS ......................................................................................................................... 2 INTRODUCTION ................................................................................................................................. 2 CAUTION - WARNING ......................................................................................................................... 3 NOTE .........................................
CAUTION - WARNING IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO: • ensure that the vehicle is parked in a safe and responsible manner. • ensure that the vehicle is not remotely started indoors (garage, underground parking). • ensure that the vehicle is not remotely started with a passenger inside. • ensure that the gearshift lever is in the NEUTRAL position and the parking brake is engaged on manual transmission in order to avoid accidents upon remote starting.
AVIS D’INDUSTRIE CANADA AUX UTILISATEURS Le fonctionnement est sujet aux deux conditions suivantes: (1) cet appareil pourrait ne pas causer d’interférence, et (2) cet appareil devrait accepter n’importe quelle interférence, même celle qui pourrait causer un fonctionnement indésirable à l’appareil.
USING THE REMOTE CONTROL The remote starter is equipped with two 4-button multi-channel remote control. + COMMAND TIME PRESSED DESCRIPTION LOCK 0,5 SEC. Locks all doors, arm the anti-theft system and activates the Alarm (if installed). Press LOCK for 3 seconds to activate the Panic Mode UNLOCK 0,5 SEC. Unlocks all doors, disarms the anti-theft system and deactivates the Alarm (if installed). START 3 SEC. Remote-start the vehicle. Press START again to reset the runtime.
Approximately 5 seconds later the engine will crank. Once the vehicle starts the parking lights will turn on and remain on for the entire duration of the Remote-Starter runtime, or until the Remote-Starter is shut down. STEP 3 If the vehicle fails to start on the first attempt, the Remote-Starter will wait 3 seconds before it will attempt to start the vehicle again. The Remote-Starter will attempt to start the vehicle 2 times (default) before giving up.
STEP 5 OFF Remove the key from the ignition barrel. The vehicle will remain running with the Remote-Starter. STEP 6 Exit the vehicle and close all of the doors. The Remote-Starter will stop running once all the doors are closed. METHOD 2 This method must be programmed by the installer during installation. THIS METHOD WILL ACTIVATE THE REMOTE STARTER SEQUENCE EVERYTIME THE END USER IS LEAVING THE VEHICLE. AUTOMATIC ACTIVATION: The vehicle must be running.
to reset this timer. To activate Idle Mode (automatic transmission) proceed with the following steps: STEP 1 STEP 2 With the key in the barrel at the ignition (ON/RUN) position and the engine running, press the START button until the parking lights turn on. OFF Turn the key to the OFF position and remove the key from the ignition barrel. The vehicle will continue to run with the Remote-Starter.
STEP 1 With the engine already running, press the remote START button until the parking lights come on. STEP 2 OFF Remove the key from the ignition barrel. The vehicle will continue to run with the the Remote-Starter. STEP 3 Exit the vehicle and close all of the doors. The vehicle will continue to run after all the doors are closed. STEP 4 Press the LOCK button to lock the doors. The vehicle will continue to run for 60 seconds.
To enter Valet Mode using the remote transmitter proceed with the following steps: STEP 1 + Press and release the FUNCTION button, within 12 seconds simultaneously press and hold the LOCK and UNLOCK buttons for 1 second. STEP 2 FMH 2 -W The LED will turn ON solid and remain ON. To exit Valet Mode using the remote transmitter proceed with the following steps: STEP 1 + Press and release the FUNCTION button, within 12 seconds simultaneously press the LOCK and UNLOCK buttons for 1 second.
Aux 2 : Passenger side sliding door (if installed). Press and relase the FUNCTION button (the remote LED flashes slowly white) within 12 seconds press the UNLOCK button. Note: The function of the auxiliary outputs may vary depending on the vehicle and the installation. In most cases these outputs are not used, and in some cases they may be used to control other features such as the power windows, sunroof, or heated seats.
ACTIVE OR PASSIVE ARMING Passive Mode will allow the Alarm to automatically rearm itself 60 seconds after it is disarmed if no door(s) (or trunk) are open(ed). Opening a door before the 60 seconds has expired will reset the timer but will also prevent the Alarm from locking the doors. This option is enabled by default and the Alarm will never arm as long as at least one door is left open.
NOTE 1: If the vehicle is running with the Remote-Starter and the Alarm is triggered the Remote-Starter will shut down immediately. This applies to Cold Start, Turbo and Idle Modes. However the vehicle can be RemoteStarted at a later time (i.e. The Alarm will not cancel Cold Start Timer). NOTE 2: When an alarm infraction has occurred the LED on the antenna will quickly flash 3 times followed of a long pause. It will continue to flash until the alarm is disabled.
TRANSMITTER RANGE Several factors may affect the operating range of the remote transmitter: • A weak transmitter battery. • The operating environment such as in the city and airports due to radio interference, cell phone towers, etc… • Several types of metal such as the vehicle itself, other vehicles, the windshields tint lines and large buildings. • The vehicle’s shape. Vans generally have poorer range. • The shape of the vehicle’s roof and the A-pillars cause considerable radio-frequency deflection.
REMOTE START / ALARM DIAGNOSTICS REMOTE STARTER DIAGNOSTICS Parking Light flashes (before starting) : 3x Ready mode disabled 4x Valet mode activated (The LED is on) 5x Hood open Parking Light flashes (after Shutdown) : 1x Normal stop (Brake, Park Brake) 3x Runtime expired or shut down by transmitter 4x No tachometer signal 5x Hood open 6x Over crank threshold (8 seconds) Page 14 / 16 ALARM DIAGNOSTICS Parking Light flashes (after disarm) : 3x Door open – zone 3 4x Shock sensor – zone 4 5x Hood open – zon
Page 15 / 16
USER GUIDE Page 16 / 16