SECURITY SYSTEM ONLY REMOTE CAR STARTER ONLY SECURITY SYSTEM AND REMOTE CAR STARTER AUTOMATIC / MANUAL TRANSMISSION - 1-WAY REMOTES DL1004 User Guide Model : DL1004 FCC ID : FCC ID: 2ACKU-DL1004 IC: 12084A-DL1004 Manufacture : FORTIN Model : ANT-FMH-2W FCC ID : 2ACKU-A2W01FM IC : 12084A-A2W01FM Manufacture : FORTIN DESIGNED & ENGINEERED IN CANADA DOC#: 68391 - REV:G 20170719 © 2017 ALL RIGHTS RESERVED
TABLE DES MATIÈRES TABLE TABLE OF OF CONTENTS CONTENTS ......................................................................................................................... 2 INTRODUCTION ................................................................................................................................. 2 CAUTION - WARNING ......................................................................................................................... 3 NOTE ........................................
CAUTION - WARNING IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO: • • • • ensure that the vehicle is parked in a safe and responsible manner. ensure that the vehicle is not remotely started indoors (garage, underground parking). ensure that the vehicle is not remotely started with a passenger inside. ensure that the gearshift lever is in the NEUTRAL position and the parking brake is engaged on manual transmission in order to avoid accidents upon remote starting.
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This device complies with the Industry Canada Radio Standards Specification RSS 210.
REMOTE-STARTING REMOTE-STARTING THE VEHICLE This Remote-Starter supports both manual and automatic transmission vehicles. For manual transmission vehicles see the Ready Mode section. REMOTE-STARTING STEP 1 To remote-start the vehicle press the START button for approximately 3second. STEP 2 The parking lights will turn on to indicate a response to the Remote-Start signal. STEP 3 Approximately 5 seconds later the engine will crank.
READY MODE (MANUAL TRANSMISSION ONLY) Two activation methods are possible, please consult the salesman or installer to determine which of these modes applies to your vehicle. There are always safety concerns for a manual transmission vehicle to accidentally start while in gear, Ready Mode alleviates these concerns. The driver must enable Ready Mode in order to Remote-Start the vehicle at a later time. Once Ready Mode is set-up the vehicle can be started/stopped at will, as many times as needed.
STEP 5 Exit the vehicle and close all of the doors. The Remote-Starter will stop running once all the doors are closed. The vehicle is ready to start. Open any door to cancel Ready Mode and start over the sequence from step 1. TO DEACTIVATE READY MODE: • Open any door(s) • Open the hood • Disengage of the parking brake Note : If the parking lights flash 3 times when Remote-Starting, Ready Mode is not enabled.
STEP 1 Ensure the transmission is in the NEUTRAL position. STEP 2 Open at least one door. STEP 3 Engage the parking brake. STEP 4 Release the brake pedal. STEP 5 Press the remote START button. The parking lights will flash once and then remain on. STEP 6 OFF STEP 7 Remove the key from the ignition barrel. The vehicle will continue to run with the the Remote-Starter. Exit the vehicle and close all of the doors. The vehicle will continue to run after all the doors are closed.
VALET MODE (VIA SWITCH) Valet Mode disables both the Remote-Starter and Alarm system. Whenever the vehicle is being serviced or repaired, or the vehicle is parked indoors it is mandatory that Valet Mode be enabled to prevent an accidental Remote-Start. Note: The alarm system is not active (including Starter Kill) when the system is in Valet Mode. However you are still able to lock and unlock the doors, and release the rear hatch/trunk.
COLD START TIMER MODE Mode will remote-start the vehicle when the tempeture is below -50C / 230F every 1.5 or 3 hours and run for 3, 5, 7 or 15 minutes (6, 14 or 30 for diesel engines), depending on programming. The remote-starter will repeat this sequence for up to a maximum of 24 hours. For manual transmission vehicle’s READY MODE must be enabled, and if at any time READY MODE is disabled this sequence will cancel. WARNING Do not start the vehicle indoors (garage, underground parking).
to any of the following settings could adversely affect the reliability of the Remote-Starter and/or the vehicle’s operation. Configurable Options: - Remote Door Locks - Security Lock - Runtime Reset - Active or Passive Arming - Trunk/Hatch Release - Secure Transmitter Mode - Ignition Door Locks - Runtime REMOTE DOOR LOCKS If the Remote-Starter is installed with door locks, you will be able to lock and unlock the vehicle without using the key or OEM key fob.
RUNTIME On gas engines the Remote-Starter can run the vehicle for either 3, 7 or 15 (default) minutes. On diesel engines the Remote-Starter can run the vehicle for either 6, 15 or 30 (default) minutes. RUNTIME RESET Once the vehicle is running with the Remote-Starter the runtime can be reset (before it expires) at any time by pressing the START button while the vehicle is Remote-Started. The horn/siren will sound once to confirm (If installed).
(If installed) and flash the parking lights. Press unlock to cancel this Mode. Note: If an Alarm pre-triggered zone is in memory, this Mode will NOT clear this zone from memory. SENSOR DEACTIVATION In cases where a sensor is too sensitive and causes false alarms, it is possible to disable some of the zones. The Shock Sensor (zone 4), Auxiliary In (zone 7) and the Tilt Sensor (zone 8). To disable all of these zones press the auxiliary AUX button followed by either the LOCK button or the UNLOCK button.
REMOTE START / ALARM DIAGNOSTICS REMOTE STARTER DIAGNOSTICS Parking Light flashes (before starting) : 3x Ready mode disabled 4x Valet mode activated (The LED is on) 5x Hood open Parking Light flashes (after Shutdown) : 1x Normal stop (Brake, Park Brake) 3x Runtime expired or shut down by transmitter 4x No tachometer signal 5x Hood open 6x Over crank threshold (8 seconds) Page 14 / 14 ALARM DIAGNOSTICS Parking Light flashes (after disarm) : 3x Door open – zone 3 4x Shock sensor – zone 4 5x Hood open – zon