User's Manual

ManualsBrandsFormosa Teletek ManualsAudio EquipmentBluetooth Headset

User Guide

Bluetooth Headset

Bluetooth your safety

Introduction

This Wireless headset is base on Bluetooth technology, connects to a

compatible phone without wires. It is easily converting your mobile

phone communication to the headset. This headset integrated CSR

BC02 and Formosa Teletek LTCC technology, providing fast and

reliable voice transmission.

Note: This bluetooth headset just supports “call receiving”

function, if bluetooth phone only has headset profile,

without handsfree profile.

It doesn’t support a bluetooth phone without headset

and handsfree profile, such as Nokia 7650.

The following page of this user manual focus on how to use this

product

olume up

olume down

Main bottom

LED

Microphone

Charger connector

Summary of content (4 pages)

PAGE 1
User Guide Bluetooth Headset Bluetooth your safety Introduction This Wireless headset is base on Bluetooth technology, connects to a compatible phone without wires. It is easily converting your mobile phone communication to the headset. This headset integrated CSR BC02 and Formosa Teletek LTCC technology, providing fast and reliable voice transmission. Note: This bluetooth headset just supports “call receiving” function, if bluetooth phone only has headset profile, without handsfree profile.
PAGE 2
Getting started Charging the battery The headset has a rechargeable Lithium Polymer battery. You have 2 ways to charge the battery: 1. Charging by the AC charger a、 Connect the charger cable to the charger connector on headset b、 Connect the charger to an AC wall outlet. The red LED is on, during charge mode. It takes around 1.5 hours to fully charge the battery. The red LED is off when the battery is full. 2.
PAGE 3
1. When the headset is off, press and hold the main bottom for 2 seconds until the blue/red LED fast flashes. 2. Prepare your phone for turning on bluetooth function, searching new device, according to the phone user’s guide. Make sure the product is within 5m of the phone. 3. “Auto Blue” appears in the pairing list on your phone. Selects it. Key-in the password “1234”. 4. The headset goes into link mode after pairing. The blue LED flashes 4 times in each 3 seconds.
PAGE 4
Redialing the last dialing number In the standby mode, long press the volume up or volume down bottom to redial the last call. Adjusting the Volume 1. To increase the volume, press the volume up bottom in talking mode. 2. To decrease the volume, press the volume down bottom in talking mode. Reject a coming call 1. When you receive a call, headset rings, and the blue LED fast flashes 3 times in each 3 seconds. 2. Long press the main button to reject the call.