Operation Manual

X-POWER 2 IN 1 WIRELESS REMOTE OPERATION MANUAL
X-POWER 2 IN 1 wireless remote is one control system integrating wire control switch and remote control
switch. The control system is used to control power in and power out of X-POWER winches.
A. Press the START button of remote, then the remote can control the winch operation;
B. Plug in the Wire Control Switch to connect with control box, then you can control the winch operation
through Wire Control Switch.
 Remote range up to 82 ft.
 Visual signal indicator.
 Charging with USB C port.
 Flashlight up to 200LM.
 Control function for fairlead LED light.
WARNING: This remote is special designed for X-POWER winch. The remote should not be used on
hoist or winches for industrial applications, include commercial car haulers/carriers, wrecker, crane,
etc.
Technical Parameter:
1. Power: Vehicle power supply 12V for Receiver, Lithium battery 3.7V for Transmitter.
2. Transmission frequency: 433MHz.
3. Ambient temperature: -20ºC ~ + 80ºC.
4. Waterproof: IP65.
5. Remote control distance: 82 feet.
6. Encoding: Learning code.
7. Adaptive voltage: 12V.
8. Transmitter: The transmitter turns off automatically without using it for ten minutes.
9. Transmitter low power alarm: When the transmitter battery voltage is below 3.4V, Blue indicator light
will flash.
Parts List:
Remote wireless transmitter: 1
PC.
Remote receiver: 1 PC.
USB-C data line: 1 PC.
Handle switch harness: 1 PC.
Installation and Connection
instruction:
The remote can be installed
inside control box. Please
connect the wire as below
connection drawing (Picture 1).