PRODUCT DESCRIPTION PRODUCT DESCRIPTION PARAMETER SPECIFICATION PARAMETER SPECIFICATION Color Temperature (6400K) Safety Compliance uL Option (4200K-3000K-6400K) IP Rate 1P54 Input Voltage AC100-240V Output Voltage 12vDC Mirror Glass 5mm CRI 85-90Ra Wiring Method Hardwired / Plug in Working Temperature 20750.
PRODUCT DESCRIPTION TWO WIRING CONNECTION SOLUTIONS 1. This led light mirror with a thickness not only copper-free and lead-free, but also is equipped with three silver and paint layers of protection, which is high quality and environmentally friendly. 2. LED lifetime: hours) Life time is 5 times longer than traditional mirror. 3.
rote: After opening the package, please inspect the product Immediately for damage In transit or missing parts. If there Is any missing, Please contact us. This manual is intent to guide the installation and care instruction. av Screws Wall anchors LED Mirror P3 Wire cap INSTALLATION TOOLS (Not included) Pencil Hammer Safely Goggles Electric Drill Phillips Screwdriver Tape Measure 07 BEFORE INSTALLATION 1.
After connecting the power, the two round buttons will turn white. At the moment the LED and anti-fog function are already on automatically. You don't need to click the button again. If you don't need to use any one of them, just touch it to turn it off, then the button will turn white. Memory Function : The status of two buttons will have been memorized in the mirror.
INSTALLATION OF LED MIRROR nel ee Tl Gps Measure the distance of four hooks center and use the level ruler to draw a horizontal line on the wall and then mark the location of the center of hooks. Drill pill Holes on the marked spots Thm Use a electric drill to punch four 6mm heels at the marked spots, and then apply wall anchors with hammer. {8mm drill bit, drilling depth Use the screwdriver to lightening the screw on the wall anchors set aside 7mm distance to wall.
Ee ee ‘You can connect these wires to a standard switched lighting culture or to a plug. If you want te connect power wires to plug, you can refer to the steps: « Remove the plug cover by either “snapping” or unscrewing it. * Unscrew the little screws on each of the plug’ s pins. «+ Insert the twisted copper wires into the holes in the pins. * Tighten the little screw on each of the plug’ s pins. + Make sure the electrical cord is firmly gripped by the arrest or clips. * Replace the cover of the plug.