Declaration of Conformity

Federal Communications Commission (FCC) Declaration of Conformity

FCC Caution: Any changes or modiﬁcations not expressly approved by the party responsible for

compliance could void the user’s authority to operate this equipment. This device complies with Part 15

of the FCC Rules. (15.247) Operation is subject to the following two conditions: (1) This device m ay not

cause harmful interference, and (2) this device must accept any interference received, including

interference that m ay cause undesired operation. This device and its antenna(s) must not be co-located

or operating in conjunction with any other antenna or transmitter.

15.105 Information to the user. (b) For a Class B digital device or peripheral, the instructions furnished

the user shall include the following or similar statement, placed in a prominent lo-cation in the text of

the manual: Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment oﬀ and on, the user

is encouraged to try to correct the interference by one or more of the following measures:—Reorient or

relocate the receiving antenna. —Increase the separation between the equipment and receiver.—Connect

the equipment into an outlet on a circuit diﬀerent from that to which the receiver is connected. —

Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20 cm between the radiator

and your body.

Radiation Exposure Statement: This equipment complies with FCC radiation expo-sure limits set forth

for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction

with any other antenna or transmitter. The availability of some speciﬁc channels and/or operational

frequency bands is country dependent and ﬁrmware programmed at the factory to match the intended

destination. The ﬁrmware setting is not accessible by the end user.

The ﬁnal end product must be labeled in a visible area with the following: “Contains Transmitter

Module FCC ID: 2AATL-6223B-UUD” This radio module must not be installed to co-locate and

operating simultaneously with other radios in host system, additional testing and equipment

authorization may be required to operating simultaneously with other radio.

This Module have RF shielding and is tested and approved as standalone conﬁguration, additional

evaluation may be required for any system integrated this radio module. External Antenna Type, with

the maximum 4.2dBi indicated.