FN-LINK TECHNOLOGY LIMITED F23BUUM13 series user 's manual http://www.fn-link.
FN-LINK TECHNOLOGY LIMITED Index How to install the driver Put the product plug into the USB port of PC……………………..3 Copy the driver into the PC……………..………….…...................3 Install the driver & Install driver successfully……….………….....6 The test interface……………………………….……......................7 Installation Guide……………………………….……..…......................8 http://www.fn-link.
FN-LINK TECHNOLOGY LIMITED 1. Put the product plug into the USB port, the "device manager" of PC is shown below: 2. Copy the corresponding driver "MP_Kit_RTL11n_8723BU_USB_v28_20131212" into the PC, and install driver, the installation methods: open the file "MP_Kit_RTL11n_8723BU_USB_v28_20131212", double click "Setup" installation program, guide to install. http://www.fn-link.
FN-LINK TECHNOLOGY LIMITED http://www.fn-link.
FN-LINK TECHNOLOGY LIMITED http://www.fn-link.
FN-LINK TECHNOLOGY LIMITED 3. After install driver successfully. the "device manager" of PC is shown below: http://www.fn-link.
FN-LINK TECHNOLOGY LIMITED 4. After install driver successfully. double click the icon " below: http://www.fn-link.
FN-LINK TECHNOLOGY LIMITED Installation Guide 1. Check RTL8723BU Module connection pin is clean for soldering. 2. Ready the Master PCB which will connect with RTL8723BU Module. Check connection pads is clean for soldering. 3. Place the Module on the Master PCB. Then solder it in sequence : 1.2.3 http://www.fn-link.
FN-LINK TECHNOLOGY LIMITED 4. After soldering, Check all pads are well connected. http://www.fn-link.
FCC Statement: The final end product must be labeled in a visible area with the following "Contains TX FCC ID:2AATL-F23BUUM13". If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 stayement is required to be availale in the users manual: This device complies with part 15 of the FCC Rules.