FS-MG41 USER MANUAL Digital Proportional Radio Control System Copyright ©2021 Flysky Technology co.
Thank you for purchasing our product, an ideal radio system for beginners or experienced users. In order to ensure your safety, and the safety of others, read this manual carefully before using this product. If you encounter any problem during use, refer to this manual first. If the problem persists, contact your local dealer or visit our service and support website : www.flysky-cn.
Contents 1.Safety ���������������������������������������������������������������������������������������������1 1.1 Safety Symbols ������������������������������������������������������������������������������������������������������ 1 1.2 Safety Guide ���������������������������������������������������������������������������������������������������������� 1 2.Introduction ������������������������������������������������������������������������������������2 2.
1.Safety 1.1 Safety Symbols Pay close attention to the following symbols and their meanings. Failure to follow these warnings could cause damage, injury or death. Danger • Not following these instructions may lead to serious injuries or death. Warning • Not following these instructions may lead to major injuries. Attention • Not following these instructions may lead to minor injuries. 1.
Digital Proportional Radio Control System FS-MG41 2.Introduction The FS-MG41 is a simplifed 4-channel transmitter that adopts the 2.4GHz ANT Automatic Frequency Hopping Digital System . The transmitter is lightweight and compact in design, comfortable and ergonomic. It has a beginner mode and is easy for beginner players to use. 2.1 Transmitter Overview [4] [1] [5] [2] [3] [6] [7] [12] [13] [8] [14] [10] [16] [9] [11] [15] [17] [18] Traversing handwheel, 35 degrees on [10] ST.
2.
Digital Proportional Radio Control System 3.Getting Started Before operation, install the battery and connect the system as instructed below. 3.1 Transmitter Battery Installation Danger • Only use specified battery (X4 AA batteries). Danger • Do not crush/puncture the battery, or short the external contacts. Danger • Do not open, disassemble, or attempt to repair the battery. Danger • Do not expose to excessive heat or liquids.
4.Instructions After setting up, follow the instructions below to operate the system. 4.1 Power On Follow the steps below to turn on the transmitter : 1. 2. Check to make sure that that batter y is fully charged and installed correctly. Toggle the switch to the [ON] position. When active the R.LED will be lit. 3. Connect the receiver to power. • For safety always power on the transmitter before the receiver. Note Note • Operate with caution in order to avoid damage or injury.
Digital Proportional Radio Control System FS-MG41 4.4 Stick Calibration T his f u n ct i o n i s u se d to set th e ne u tra l position for throttle and wheel. Ever y transmitter is calibrated before leaving the factor y, howe ver if recalibration is re q u i red , p l ea s e fo l l ow th e se ste ps: 1.
5.System Functions This section focuses on the functions and how to use them. 5.1 Channel Description The t ran s m i tter o u tpu ts a tota l o f 4 c h a n nels, which are allocated as follows: • • • • CH1:Steering Wheel CH2:Throttle Trigger CH3:Three-position Switch CH4:Key Switch N ote: By d efau l t th e o u tpu t o f C H4 i s 1 0 00us, after which p ressing the button will toggle b et ween 1000 and 2 0 0 0 u s. 5.
Digital Proportional Radio Control System FS-MG41 5.4 D/R T h e ST. D/ R is t h e t ri m s for CH1 (ste e ri ng ),and can be multiplexed as Trims o f CH3 ; T h e ST. D/ R is t h e t ri m s for CH2(t h rottle).and can be multiplexed as Trims o f CH4 ; Fo r m ul t ip l ex i ng sw i tch i ng m ode , se e [5 .5 Mo de Switching ]. A d j u st m en t range : 0-120%; ST. D/ R : co un te rc l ockw i se adj u st m e nt to increas e the s er vo amo unt . The maximum value is 120%. ST.
5.7 Beginner Mode Begi n n er m o d e i s de si gne d fo r pe o pl e ne w to the hobby. In t h i s m o d e t h e th rottl e w i l l be l i mi te d to 50 p ercent , T he channel range d efaults to 1 2 5 0~1500~1750u s. Set u p : To s w i tc h b et we e n begi nne r a nd no rma l mod es p ress and hold the channel 4 button as th e t ra n s mi tter i s t u rne d o n. N ote: By d efau l t , th e syste m i s set to no r mal mod e.
Digital Proportional Radio Control System FS-MG41 Pa ra m ete r Ex p l a n ation : 1 . R u n n i n g Mo d e F W D/ RE V/ B RK : T h i s mo de a do pts " do u bl e click” re verse mod e, that is, when the throttle t r igger is pushed from netural range to the re verse area for the first time, the motor is only braking and w ill n ot re vers e; w h e n th e th rottl e tri gger is moved back to the netural range and p ushed to t he re ve rs e a rea fo r th e se co nd ti me , i t w i l l re verse.
7. Product Specifications This section contains FS-HW-MG41 transmitter and HW709 receiver specifications. 7.1 Transmitter Specification( FS-MG41) Product Model FS-MG41 Model Type Car, Boat Channels RF RF Power 2.4GHz Protocol Distance Channel Resolution Battery Charging Interface Life time Low Voltage Warning Antenna Type Data Interface Temperature Range Humidity Range Online Update Color size weight Certification 7.2 Receiver Specification FS -R 4 A : 4 2.
Digital Proportional Radio Control System H W- 7 0 9 : FS-MG41 Product Model HW-709 Main applications 1/16、1/18 On- road, Buggy, SCT, Truck and Rock Crawler Continuous / peak current 25A / 120A Applicable motor LiPo/NiMH Cells Parameter setting PWM Channels RF 2.4GHz Protocol RF Power Distance Antenna Type RSSI Data Interface Temperature Range Humidity Range Online Update weight size Certification H W- 7 1 1 : 280/370 brushed motor ≥ 12T or RPM < 30000 @7.
8.
Digital Proportional Radio Control System FS-MG41 9. Certification 9.1 DoC Declaration Hereby, [Flysky Technology co., ltd] declares that the Radio Equipment [FS-MG41] is in compliance with RED 2014/53/EU. The full text of the EU DoC is available at the following internet address: www.flysky-cn.com. 9.
10. Environmentally friendly disposal Old electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at the communal collecting point via private persons is for free. The owner of old appliances is responsible to bring the appliances to these collecting points or to similar collection points. With this little personal effort, you contribute to recycle valuable raw materials and the treatment of toxic substances.
www.flysky-cn.com Copyright ©2021Flysky Technology co.