FS-GT2F Digital propotional radio control system 用户手册 http://www.flysky-cn.com Copyright ©2013-2017 FlyskyRC model technology co.
Table of contents 1. Introduction 简介......................................................................................................................................................... 2 2. Services 服务.................................................................................................................................................................. 2 3.special symbols特殊标志 .......................................................................................................................
Digital propotional radio control system FS-GT2F 1. Introduction 简介 Thank you for choosing 2.4G ratio remote control digital products,if you are the first time to use this type of products,please read this statement carefully and strictly in accordance with the requirements of operation.You could refer to the manual if you meet any problems during the operation.Please well keep the manual after use because you might have to use it again next time.Once again,thanks for buying our products. 感谢您选择使用 2.
3. Special symbols 特殊标志 Please pay attention to the following symbols when it appears on the manual and read carefully. 此说明书中有如下符号的地方请您特别注意，并仔细阅读。 If the operator does not operate by following the instructions,the operator may lead to serious injuries,even mortal danger. 如果操作者不按正常操作方法操作，有可能导致操作者严重受伤，甚至致命危险。 If the operator does not operate by following the instructions, the operator may lead to serious injuries,even mortal danger.
Digital propotional radio control system FS-GT2F Be sure to set the Fail Safe function. 一定要启用防失控功能. Do not operate outdoors on rainy days, run through puddles of water or use when visibility is limited. Should any type of moisture (water or snow) enter any component of the system, erratic operation and loss of control may occur. 不要在户外雨天,有水的地方或当能见度有限的时候使用。可能水分(水或雪)会进入到系统内部,不稳定的运行 和失控可能发生。 Do not operate in the following places. -Near other sites where other radio control activity may occur.
5. 2.4GHz System/Characteristic 5.01. AFHDS 2.4G系统/系统特征 自动跳频数字系统 AFHDS（automatic frequency hopping digital system),is developed by FLYSKY for all the Radio Control model lovers and is patented by FLYSKY at home.The system is specially developed for all the Radio control models,thar offers super active and passive antijamming capabilities,ver y low power consumption and high receiver sensitivity.
Digital propotional radio control system FS-GT2F 5.03. AFHDS2A 第二代增强版自动跳频数字系统 AFHDS2A (automatic frequency hopping digital system 2A) is the digital radio system with independent intellectual property, which is newly developed by FLYSKY. This system is developed specially for high-end model products. As the one of the best system in the market, it has built-in multiple channel coding, error-correction, longer communication distance and more powerful antijamming capability.
AFHDS2A system has the automatic identification function, which can switch automatically current mode between single-way communication mode and two-way communication mode according to customer needs. The two-way communication mode with data return function can help users understand current working status better and make the fight more enjoyable.
Digital propotional radio control system FS-GT2F 7. Transmitter specifications 发射机参数 Transmitter specifications: Channels: 2 Model type: car/boat RF range:2.405-2.475GHz Bandwidth:500KHz Band:142 RF power: less than18 dBm 2.4G system: AFHDS2A and AFHDS Code type: GFSK Sensitivity: 1024 Low voltage warning: less than 4.2V DSC port: Micro-USB PPM ST range:70 L:35 R:35 TH range:45 F:35 B:15 Charger port: no ANT length: 26mm Weight: 323g Power: 6V DC 1.
9.Receiver and servo connections 接收机与伺服器连接 9.01. Installation when a motor controller is used 带马达模型的安装连接 调速器 开关 伺服器 马达 电池 接收机 Remark: Place the receiver antenna upright and perpendicular to the horizontal plane Keep the receiver antenna away from any metal objects to ensure max sensitivity.
Digital propotional radio control system FS-GT2F 9.02.
10. 2.4GHz Operation notes 10.01. Matching(code)/Binding 2.4G操作注意事项 对码 All receivers are already paired with their respective transmitter during production. If you wish to bind it with another transmitter, please follow the instructions below. Remark: FS - brand system are not compatible with other brands Steps: 1. Ensure you are using AFHDS2A system 2. Correctly install the battery inside 2.4G transmitter w/o powering it on. 3. Insert the binding plug into the BIND channel slot on the receiver. (Figure.
Digital propotional radio control system FS-GT2F 10.02 Power on 开机 A. Connect every part. B. Switch on the power supply of the transmitter. C. Connect the power supply of the receiuer. D. Receive LED light solid. E. Finish and use. 1. 将各部件链接好； 2. 打开发射机电源开关； 3. 连通接收机电源； 4.接收机LED恒亮； 5.使用。 Tx power ON 10.3 Shut down Rx power ON 关机 A. Connect every part. B. Cut off the transmitter power supply. Rx power off 1. 关闭接收机的电源； 2.
11. each part of the transmitter 发射机部件 Front 5 6 8 9 7 10 11 4 3 2 12 1 13 1 对码键 BIND Key 2 电源指示灯 POWER LED 3 S T倒置开关 ST REV 4 电源开关 POWER ON/OFF 5 数据输出接口 DSC FOR SIMULATE 6 S T 中位微调 ST TRIM 7 T H 倒置开关 TH REV 14 8 T H 中位微调 TH TRIM 9 12 10 工作指示灯 POWER CHECK 11 油门比例微调 TH,M,P 13 油门扳机THROTTLE TRIGGER 14 电池盒 BAT BOX S T通道比例微调 ST D/R 方向调轮 STEERING WHEEL 油门比例微调TH,M,P On some model, the travel of the throttle is not equal to the travel of the brakes.
Digital propotional radio control system FS-GT2F 12. Transmitter function notes 12.01. Steering control 发射机功能说明 方向控制 Function Introduction: This function is to control the direction,when the steering turn to right then the front wheel will turn to right (as picture),when the steering turn to left then the front wheel will turn to left(as picture). Operation Method: Adjust the dual rate of the steering by adjusting the D/R knob.
12.02 Throttle control 油门控制 Function Introduction: This function is to control the throttle speed,when pull the rhrotte trigger back,car will accelerate forward(see the picture),when push the throttle trigger,the car will put on the brakes or double ring asterm(according to the different ESC)(see thepicture). Operation Method: To control it by pushing and pulling back the throttle trigger after power on.
Digital propotional radio control system FS-GT2F 13. Fail safefunction 13.01 Failsafe Instruction 接收机操作说明 失控保护功能说明 FAIL SAFE FUNCTION 1.Function Failsafe aims to prevent out- of- control driving of RC car orRC boat. If the Receiver is not able to receive any signal, from the control to throttle,the parameter of throttle on receiver will turn back to its original setting. 2. Setting a.Turn on the Transmitter switch; b. Turn on the Receiver switch.the LEDwill be lighting; c.
14. Simulation 模拟 Introduction: The following is for the virtual RC racing practice on computer, and you can also play simulated competition on the computer. Operation Methods: 1.Using FS-SM102 simulator cable, please insert the micro USB plug into Transmitter, and the USB plug into a PC. 2.Switch on the Transmitter. 3. Start VRC software on your PC. 4. Follow the on-screen instructions to customize user setting Remark: VRC software provided is free and only offers one track and training ground.
Digital propotional radio control system FS-GT2F 15.
16. Packaging content 1 2 channel 2.4G transmitter(FS-GT2F) 包装内容 1 2 通2.4G发射 2 3 channel 2.4G receiver(FS-A3) 1 3 通2.
Digital propotional radio control system http://www.flysky-cn.com Copyright ©2013-2017 Flysky co.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
