Installation Instructions

X1
X1
Q： Why only one side have sound or have two same earbuds in Bluetooth list
A： Please reset the earbuds by holding the pair button on the case for 15S till the
Red flash, Keep holding it untill red and blue flash. The reset is complete.
Q:仅单耳出声或蓝牙搜索出两个相同设备名
A：TWS左右耳配对，长按对码键15s至红灯闪烁； 20s后红蓝灯交替闪后即可配对设备
Q:僅單耳出聲或藍牙搜索出兩個相同設備名
A：TWS左右耳配對，長按對碼鍵15s至紅燈閃爍； 20s後紅藍燈交替閃後即可配對設備
Q : 한쪽 이어폰만 소리가 나거나 Bluetooth가 두 개의 동일한 장치를 검색합니다
A : 리셋을 위하여 빨간색 표시등이 깜박일 때까지 페어링 버튼을 15초 동안 길게
누릅니다. 빨간색과 파란색 표시등이 번갈아 깜박일 때까지 누르면 리셋이 완료됩니다
“FLYDIGI Cyberfox X1”
New Generation Flydigi Foxspeed™ Low Latency
Technology.
Real Latency-Insensitive Wireless Sound
Experience
第三代飞智Foxspeed™低延迟技术，
真·有线级无感延迟体验
第三代飛智Foxspeed™低延遲技術，
真·有線級無感延遲體驗
새로운 세대의 Flydigi Foxspeed™저지연 기술.
실제 유선 수준의 지연 없는 사운드 제공
连接其他设备
打开耳机盒，长按对码键3s直到指示灯红蓝交
替闪烁，前往“蓝牙”设置并选取“FLYDIGI
Cyberfox X1”。
連線其他裝置
打開耳機盒,長按對碼鍵3s直到指示燈紅藍交
替閃爍,前往“藍牙”設定並選取“FLYDIGI
Cyberfox X1”。
Connection to Other Devices
Open earphone case and long press
“connect button” for 3 seconds until you
see an alternation of blue and red blinks.
Then go to bluetooth setting-Blue-
tooth-Choose "FLYDIGI Cyberfox X1"
X1
X1
X1
X1
기타 기기 연결
이어폰 박스를 열고 코드 키를 3초 동안 누르면
표시등이 빨간색과 파란색으로 번갈아
깜박입니다. 풀린 후 "블루투스"설정으로
이동하여"FLYDIGI Cyberfox X1"을 선택하십시오.
X1
X1
X1
Download Flydigi Game Center
下载飞智游戏厅APP
Subscribe To Our WeChat
关注飞智微信公众号
FAQ
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a
class B digital device,pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequence energy and,
if not installed and used in accordance with the instructions,may cause harmful
interference to radio communications.However,there is no guarantee that interference
will not occur in a particular installation.if this equipmemt does cause harmful
interference to radio or television reception,which can be determined by turning
the equipment off and on,the user is encouraged to try to correct the interference
by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an autlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The devicecan be used in portable exposure condition without restrictio