Instructions / Assembly

Pumpkin Chair FHPC100 Assembly Instructions
1. Open the package
and unwrap the four
short legs and put
rubber feet on each of
the four legs (if not
already attached).
3. Attach upper bow to
lower bow to make C-
frame, attach using 2
longest nuts and bolts.
4. Open Pumpkin Chair
Frame completely and
put the four smallest
nuts and bolts in place.
Make sure the flat tops
are on the inside of the
chair, so they do not
poke through the fabric
or through the seat.
5. Take the center loop
and slide through top
flap opening.
Proceed to close top
and bottom flaps by
connecting hooks to
eyelets.
7. Pull the center strap
taut through the
stacked O-rings.
9. Make sure all nuts
and bolts are tightened
throughout the stand
and chair. Place in any
level location and enjoy
your Pumpkin Chair!
Thank you for your
business!
6. One at a time, slide the
O-rings of the side straps
over the center
attachment strap.
8. Lift the chair and slide
the attachment strap
over the end cap into
the securing tabs.
Place flat cushion in
chair, followed by large
over-stuffed cushion.
• PO Box 595 Clio, Michigan 48458 • Office: (810)-686-8252 • Fax: [phone] • [e-mail] •
2. Connect the four
legs to the X-frame
on the lower bow of
the Pumpkin Chair
Stand using the 4
shorter nuts and
bolts.
PATENTS:
www.flowerhouses.com/patents