Instructions / Assembly

Table Of Contents

BUTTERFLY BENCH ASSEMBLY INSTRUCTIONS

The tools provided are a 9 cm open end wrench and a 7 cm allen wrench for Body Wings,

Seat, and Antenna assembly.

Step 1: Start by bolting wings to butterfly body. Body goes on the BACK of wings and

will “face” towards the back. (do not fully tighten until all fasteners are in place on entire

bench).

Step 2: Place seat in position and start fasteners. Seat portion will set donwn on top of the

four mounting tabs. (do not fully tighten until all fasteners are in place on entire bench).

Step 3: Place antenna in position and start fasteners. With all the fasteners loose, you may

need to physically rock the bench around to align the holes.

Step 4: Snug nuts and bolts gradually by moving from fastener location on body, wings,

seat and antenna with Allen key and open end wrench.

Step 5: Once the fasteners are consistently tightened then your Butterfly Bench is ready

to be used as a bench.

PAGE 1
BUTTERFLY BENCH ASSEMBLY INSTRUCTIONS The tools provided are a 9 cm open end wrench and a 7 cm allen wrench for Body Wings, Seat, and Antenna assembly. Step 1: Start by bolting wings to butterfly body. Body goes on the BACK of wings and will “face” towards the back. (do not fully tighten until all fasteners are in place on entire bench). Step 2: Place seat in position and start fasteners. Seat portion will set donwn on top of the four mounting tabs.
PAGE 2
BUTTERFLY CHAIR ASSEMBLY INSTRUCTIONS The tools provided are a 9 cm open end wrench and 7 cm allen wrench for Body Wings and Seat and 6 cm Allen key for Antenna assembly. Step 1: Start by bolting wings to butterfly body. The butterfly body will attach to the BACK of the wings, facing the back. (do not fully tighten until all fasteners are in place on entire chair). Step 2: Place seat in position and start fasteners. Seat portion will set down on top of the four mounting tabs.
PAGE 3
BUTTERFLY TABLE ASSEMBLY INSTRUCTIONS The tools provided are a 9 cm open end wrench and a 7 cm allen wrench for leaf and tabletop. Step 1: Start by bolting leaf to worm and trunk (do not fully tighten until all fasteners are in place on entire table). Step 2: Place tabletop in position and start fasteners (do not fully tighten until all fasteners are in place on entire table). Step 3: Snug nuts and bolts gradually by moving from fastener location on leaf and tabletop with Allen key and open end wrench.