Installation Guide

Waterproof Compression Gland
CB-4S-31 Adaptor Plate for Bullet Camera and
CB-WLBX-31 Junction Box for Bullet Camera
Installation Guide
1. Product Overview
FIGURE 1-1: ADAPTOR PLATE DIMENSIONS
The Adaptor plate is used to attach the bullet camera to the
mounting surface or to a junction box which is attached to the
mounting surface.
2. Installation and Mounting
Package Contents
Check if everything in the package matches your purchase order
form and packing slip. The package should include the following
items:
 1x Adaptor plate
 3x M4x8L screws
 2x M4x15L screws
 1x Printed quick guide
Please contact your dealer if any item is missing.
Required Tools
Use the following tools to complete the installation:
 A drill
 A Phillips head screwdriver
 A T20 torx wrench
 Wire cutters
Connecting the Camera to the Adaptor Plate
Prior to assembly, mount the adaptor plate onto the site
surface, using Single Gang, Dual Gang, or 4S mounting. Use
a Phillips screwdriver to tighten the bullet camera body to the
adaptor plate by fastening the three supplied M4x8L screws.
FIGURE 2-1: FASTEN CAMERA TO ADAPTOR PLATE
The bullet camera is mounted onto the site surface with the
adaptor plate assembled as illustrated below:
FIGURE 2-2: COMPLETED ASSEMBLY
Connecting Camera, Adaptor Plate, and Junction Box
If your site installation requires you to attach the camera to
a junction box, select either side conduit installation or
bottom conduit installation (see figures below). Feed the
cable through the waterproof compression gland. Then
tightly screw the compression gland clockwise onto the
side or bottom conduit hole of the junction box.
FIGURE 2-3: SIDE CONDUIT JUNCTION BOX INSTALLATION
FIGURE 2-4: BOTTOM CONDUIT JUNCTION BOX INSTALLATION
Prior to assembly, mount the adaptor plate using either
Single Gang, Dual Gang, or 4S mounting technique.
1
1
2
2