Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix L: Client: Model: Standards: FCC/IC ID: Report #: Fleetwood Group, Inc. V240S FCC 15.249/IC RSS-210 FBRV240S/1859A-V240S 2010235 Manual Please refer to the following pages.
USER MANUAL V240S Module
Copyright 2007 Fleetwood Group, Inc., Electronics Division. All rights reserved. Licensed software products are owned by Fleetwood Group, Inc. or its suppliers and are protected by United States copyright laws and international treaty provisions. Fleetwood Group, Inc. products are covered by U.S. and foreign patents, issued and pending. Information in this publication supersedes that in all previously published material. Specifications and pricing are subject to change without notice. Printed in the U.S.A.
Table of Contents 1.0 V240S MODULE .................................................................................................................................................. 4 1.1 DESCRIPTION ....................................................................................................................................................... 4 1.2 BATTERY REPLACEMENT .....................................................................................................................................
1.0 V240S Module 1.1 Description The V240S is a low power real time locating system sensor. The V240S module is used to identify the location of an individual or asset location. It communicates at 2.4GHz, to a badge module or a link module, and uses an IR receiver that receives data from a badge to determine its location. The overall operation of the V240S module is controlled by a microcontroller. This microcontroller is powered from an internally regulated supply, and uses a 16 MHz reference.
1.5 FCC/IC Compliance This device complies with Part 15 of the FCC Rules and RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The user is cautioned that changes or modifications to the device that are not approved by the manufacturer could void the user’s authority to operate the device.
