User's Manual

Fleetwood Group Inc. FCC ID: FBRIQK1000-9SS Page 1 of 3

File Name: IQK1000_Manual User Manual Date: 4/22/2003

Reply IQ User Manual

System Setup

1. Unpack the Reply IQB500 base unit and set it on a table or available surface in the

vicinity of where the Reply IQK1000 Response Keypads will be used.

2. Plug the AC power module into the Reply IQ base DC input jack.

3. Plug the AC line cord from the power module into a 115 VAC power circuit.

4. Turn on the power switch of the Reply IQ base unit.

5. Plug either the RJ45 supplied cable into a network port, if Ethernet connection

selected (or directly to a PC via a crossover cable), or a standard DB9 to DB9 RS232

cable into a COM port (usually Com1 or Com2) if serial connection selected.

6. Open the carrying case containing the response keypads and distribute them to the

participants.

7. Turn on the computer and start the application software to control the base unit to

poll for keypad responses. Each application software will have its own instructions for

using the system.

Operation

1. Instruct the participants on the usage of the response keypads and procedure for

responding.

2. Ask a question and allow enough time (at least 10 seconds) for all participants to

respond.

3. Observe the results on the screen and optionally save the results for later analysis if

desired.

4. Proceed and repeat the process for the next question.

5. Continue until all questions are completed.

6. Analyze the responses for the period and run printouts if desired.

System Shutdown

1. Turn off the power to the computer.

2. Turn off the power to the Reply IQ base unit.

3. Unplug the data cable from the computer and store it in its carrying case.

4. Unplug the AC line cord from the power module and store both in the carrying case.

5. Store the Reply IQ in its carrying case.

6. Collect the keypads and return them to their carrying case.

7. The system is now ready for transporting.

PAGE 1
Reply IQ User Manual System Setup 1. Unpack the Reply IQB500 base unit and set it on a table or available surface in the vicinity of where the Reply IQK1000 Response Keypads will be used. 2. Plug the AC power module into the Reply IQ base DC input jack. 3. Plug the AC line cord from the power module into a 115 VAC power circuit. 4. Turn on the power switch of the Reply IQ base unit. 5.
PAGE 2
Reply IQ Keypad Operation The reply IQ keypad has 5 basic modes of operation: Single-Digit Entry, Multi-Digit Entry, Moment to Moment Entry, Speed Scoring, and the Options menu. From a power-off state, simply press any key to turn the keypad power on. The REPLY IQ Logo along with the keypad’s address and channel will be displayed briefly and then the keypad will enter normal operation in the mode most recently used. Single Digit Entry Mode In this mode, only one key press can be sent at a time.
PAGE 3
record the time stamp on either the last key pressed or time stamp on the SEND key only. Options Menu To access the Reply IQ keypad configuration menu, press “Í” and “1” at the same time when the keypad is any of the modes listed above.