User's Manual

Table Of Contents

USER Manual

13.56M RFID DeskTop USB READER

Please read the user manual carefully before using the device

Federal Communications Commission (FCC) Statement. This device

complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide Reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications made to this device not expressly

approved by ShenZhen YanShen Electronic Co., Ltd may void the FCC

authorization to operate this device.

Note: The manufacturer is not responsible for any radio or TV

interference caused by unauthorized modifications to this equipment.

Such modifications could void the user’s authority to operate the

equipment.

RF exposure statement: The device compliance RF exposure

requirement and can installed and used without restriction

PAGE 1
Federal Communications Commission (FCC) Statement. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 2
FissaiD 13.56M Smart RFID Card reader writer Operation Manual 1. Product Profile EasyMF is designed as an external input device to read Mifare14443A type A(or compatible) RFID card UID and send data to host machine (PC/ Mac/Android device) via USB interface according to the specified format, total 28 formats can be selected by user. It also can be set in Writer mode to read and write mifare S50/S70 sector data.
PAGE 3
Federal Communications Commission (FCC) Statement. This device complies with part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.