Y3635 Please keep this instruction sheet for future reference, as it contains important information. Requires four "AA" (LR6) alkaline batteries (not included) for operation. Adult assembly is required. Tool required for assembly: Phillips screwdriver (not included). CAUTION This package contains small parts. For adult assembly only. fisher-price.
US Instructions US Te CONSUMER ASSISTANCE 1-800-432-5437 (US & Canada) 1300 135 312 (Australia) Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052. Hearing-impaired consumers: 1-800-382-7470. Fisher-P Hearing- Outside the United States: Outside Canada: Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2; www.service.mattel.com. Canada: Mississa Great Britain: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303. www.service.mattel.
Consumer Information WARNING Prevent Entanglement Injury • Keep out of baby’s reach. • Remove mobile from crib or playpen when baby begins to push up on hands and knees. • This product may not attach to all crib designs. Do not add additional strings or straps to attach to crib or playpen. • Use ONLY attached to a crib or playpen. IMPORTANT! Always attach with all provided fasteners tightly to a crib or playpen according to the instructions. Do not add additional strings or straps to attach to a crib.
Battery Installation 1,5V x 4 “AA” (LR6) We recommend using alkaline batteries for longer battery life. • Loosen the screws in the battery compartment door with a Phillips screwdriver and remove the door. • Insert four "AA" (LR6) alkaline batteries. • Replace the battery compartment door and tighten the screws. • If this product begins to operate erratically, you may need to reset the electronics. Slide the power/volume switch on the mobile base off and then back on.
Assembly Mobile Arm Crib Connector (Back) Crib Connector (Front) Mobile • Fit the front half and the back half of the crib connector to the mobile arm. • Insert three 3,5 mm x 14 mm washer head screws into the back of the crib connector and tighten with a Phillips screwdriver. Do not over-tighten. • Fit the mobile onto the end of the mobile arm. Push to "snap" in place. Pull on the mobile to be sure it is secure to the mobile arm.
Crib Attachment Slot B Crib Top Rail A D 1 C Peg • Fit the toy to crib top rail, facing the inside of the crib. Make sure the attachment strap is on the outside of the crib A . • Slide the end of the attachment strap down through the slot on the back of the toy B . Pull the end of the attachment strap up and fasten to the slot on the peg on the back of the toy C . Note: This toy should be snug against the crib rail and spindles. Use the strap slot that provides the tightest fit.
Crib Attachment 2 • Tie the toy strings to a crib spindle. Note: It is better the tie the strings in a knot than a bow, since a bow may be easily untied. Bottom of toy At Least 7 Inches (18 cm) Mattress 3 • If the distance between the bottom of the toy and the mattress is less than 7 Inches (18 cm), lower the crib mattress.
Music, Lights, Motion! Start/Stop Button Press the button to start the music/sounds. Press the button again to advance to the next song. Press and hold the button to stop the music/sounds. Power/Volume Switch ON with low volume ON with high volume OFF Sound Select Switch Nature Sounds Music Projector Switch Projector Only Projector and Lights Mode Switch Music & Motion Music Only Music & Lights Music, Lights & Motion Hint: The music/sounds will play for approximately 30 minutes.