X3844 IMPORTANT! KEEP FOR FUTURE REFERENCE. www.fisher-price.co.
Consumer Information Care • The pad and head support are machine washable. Wash them separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly. • The frame, toy bar and toys may be wiped clean using a mild cleaning solution and damp cloth. Do not immerse the toy bar. Do not use bleach. Do not use harsh or abrasive cleaners. Rinse clean with water to remove residue.
Parts IMPORTANT! Please remove all parts from the package and identify them before assembly. Some parts may be packed in the pad. Toy Bar Head Support Seat Back Tube Pad 2 Retainers Footrest 2 Toys Left Base Wire Right Base Wire Base Tube 2 Feet M5 x 20 mm Screw – 2 #8 x 2,2 cm Screw – 2 Note: Screws shown actual size. Tighten or loosen all screws with a Phillips screwdriver. Do not over-tighten the screws.
Assembly IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts. Footrest Base Tube Base Wires Left Base Wire Right Base Wire 1 4 • Place the base tube on a flat surface. • Position the left and right base wires as shown. • Fit the left base wire and right base wire into the base tube.
Assembly Pad Lower Pocket 8 Retainers • Fit the lower pocket on the back of the pad onto the footrest. 6 Toy Bar Retainer • Fit a retainer to the inside of each end of the seat back tube. • Insert #8 x 2,2 cm screw into the outside hole in the ends of the seat back tube and tighten. • Pull the seat back tube up to be sure it is secure. If you can remove either end of the seat back tube, you have not assembled the retainers correctly. Remove the screws, re-read and repeat. Assembly steps 5 and 6.
Assembly Battery Installation Hint: We recommend using alkaline batteries for longer battery life. Toy Bar 1,5V “D” (LR20) – + Toy Bar Retainer 1,5V “AAA” (LR03) • Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities. Latch 11 B • Insert and “snap” the toy bar into the toy bar retainer. • Press the latch the end of the toy bar to the tab on the socket. Hint: The toy bar is removable.
Setup and Use Battery Installation WARNING To prevent serious injury or death: • Fall Hazard - Never use on any elevated surface, since child’s movement may cause product to slide or tip over. Use only on a floor. • Suffocation Hazard - Never use on a soft surface (bed, sofa, cushion) since product can tip over and cause suffocation in soft surfaces. • Never use as a carrier or lift while child is seated. Never use toy bar to carry product. • Always use the restraint system.
Setup and Use Soothing Unit and Toy Bar Restraint System PULL 2 Power Switch • Tighten each waist belt so that the restraint system em is snug against your child. Please refer to the next section for instructions structions to tighten the waist belts. Anchored End A Anchored End B A B Free End Free End 3 • Make sure your child is properly secured in the seat. • Slide the power switch to: Vibrations or Off.