T4264 www.fisher-price.
Consumer Information Assembled Parts WARNING To prevent entanglement injury, never place the gym in a crib or playpen. Never add strings, ties or other products to the gym. Hub • Please keep this instruction sheet for future reference, as it contains important information. • Requires three “AA” (LR6) alkaline batteries (not included). • Adult assembly is required. • Tool required for assembly: Phillips screwdriver (not included).
Setup Tube 11 • Slide a tube through one of the sleeves on the quilt. Hint: You may need to adjust the fabric on the sleeve after you insert the tube. • Repeat this procedure to attach the remaining tubes. Tab 31 Elastic Loop • Insert the foot at the bottom of each tube through the elastic loops on the quilt. • Make sure the elastic loop is fitted below the tab on each tube. Hub Tube 21 41 • Insert the ends of the tubes into the sockets in the hub. Make sure you hear a "snap".
Battery Safety Information FCC Statement In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartment. • Remove batteries during long periods of non-use. Always remove exhausted batteries from the product.
Battery Installation Music, Lights and Ocean Friends! 1,5V x 3 “AA” (LR6) Mode Button • Slide the power/volume switch on the top of the hub to ON with low volume , or ON with . high volume • Press the mode button to play up to 20 minutes of fun sounds and lights! • Press the button again to turn long play mode off and let baby's movement activate sounds and lights! • When you are finished playing with this toy, . slide the power/volume switch OFF • Locate the battery compartment on the top of the hub.
Storage PRESS Hub Tube 31 • Fold the quilt in half, as shown. • Then, fold in half again. 11 Storage Strap • Press the button above each tube on the hub to release the tubes. Storage Loop 41 • Slide one end of the storage strap through the storage loop. • Fasten the ends of the storage strap. Hub 21 • Lay the tubes across the center of the quilt. • Place the hub under one of the mesh arches, as shown.