T4201 Infant Rocker Seat Recline Position Toddler Rocker Upright Position IMPORTANT! KEEP FOR FUTURE REFERENCE. www.fisher-price.co.
Consumer Information Care • The pad is machine washable. Wash the pad separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly. • The frame, toy bar and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not use bleach. Do not use harsh or abrasive cleaners. Rinse clean with water to remove residue. Do not immerse the frame, toy bar and toys. To remove the pad: • Unfasten the waist belts.
Parts Assembly IMPORTANT! Please remove all parts from the package and identify them before assembly. Some parts may be packed in the pad. CAUTION This package contains small parts in its unassembled state. Adult assembly is required. IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts.
Assembly PRESS BUTTONS Back Crossbar Side Rails 4 2 Screws • Insert a screw through the outside hole in each side rail and into the ends of the front crossbar. IMPORTANT! Please follow the next assembly step (step 5) carefully to completely secure the front crossbar to the side rails. • While pressing the buttons on the ends of the back crossbar, insert into the ends of the side rails. Push the back crossbar until the buttons "click" into place. Make sure you hear a “click” on each side.
Assembly Pad Kickstand 6 8 • Fit the kickstand onto the assembly, as shown. • Fit the pad pocket onto the seat back tube. Waist Belts Screws 7 Screws • Insert four screws into the kickstand and tighten. 9 BACK VIEW • Insert the waist belts through slots in the back of the pad. • Press the fastener on the waist belts and pad together.
Assembly Battery Installation Hint: We recommend using an alkaline battery for longer battery life. + 1,5V “D” (LR20) - • Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities (Europe only). Pad Buckles • Locate the battery compartment on the bottom of the vibrations unit. • Loosen the screw in the battery compartment door. Lift to remove the battery compartment door.
Setup and Use Infant - Recline WARNING To prevent serious injury or death: • Fall Hazard - Never use this product on an elevated surface, since child’s movement may cause the product to slide or tip over. Use only on a floor. • Suffocation Hazard - Never use on a soft surface (bed, sofa, cushion) since the product can tip over and cause suffocation in soft surfaces. • Never leave child unattended. • Never use as a carrier or lift while child is seated.
Infant - Recline Anchored End Toddler - Upright Anchored End 1 4 BACK VIEW Free End Free End TIGHTEN Seat Position • Fasten the straps on the back of the pad for the Toddler-Upright Position. LOOSEN To tighten the belts: • Feed the anchored end of the restraint belt up through the buckle to form a loop A . Pull the free end of the restraint belt B . To loosen the belts: • Feed the free end of the restraint belt up through the buckle to form a loop A .