M7332 www.fisher-price.
Consumer Information • Please keep this instruction sheet for future reference, as it contains important information. • Adult assembly is required. • Tools needed for assembly: Hammer, Phillips Screwdriver and Scrap Block of Wood (not included). • Age: 2 - 6 years; Weight Limit: 60 lbs (27 kg). • Please save all packaging material until assembly is complete to ensure that no parts are discarded. • Please wipe each part with a clean, dry cloth before assembly.
Parts Note: Some parts shown are assembled to both sides of the trike.
Assembly Rear Wheel Indented Side Up Cap Nut Hubcap Straight Axle Frame Cover Hubcap Rear Wheel Indented Side Down Hubcap 1 Assembled Rear Wheel Straight Axle 3 • Slide a hubcap (peg side up) onto the straight axle. • Slide a rear wheel (indented side down) onto the straight axle. • Place a scrap block of wood on a flat surface. • Turn the frame on its side with the exposed end of the straight axle up. • Place the cap nut assembly tool under the assembled rear wheel and onto the cap nut.
Assembly Pedal Hub Tab Pedal Hub Pedal Axle Pedal Axle Tab Slot Pedal Hub 4 Pedal Hub • Fit two pedal hubs onto the pedal axle tabs. Make sure the tabs fit into the slot in each pedal hub. 6 Pedal Hubs Pedal Axle • Turn the front wheel assembly over. • Insert a pedal hub onto the top of the pedal axle and into the hole in the center of the front wheel. • Insert the remaining pedal hub below the pedal axle and into the hole in the center of the front wheel.
Assembly Fork Arms Fork Cover Cap Groove 8 10 Pedal Axle • Place the front wheel assembly between the fork arms. Make sure the pedal axle fits into the groove at the bottom of each fork arm. • Place a fork cover over the pedal axle on one fork arm. • Insert two #8 x 3/ 4" screws through the fork cover and into the fork arm. Tighten the screws with a Phillips screwdriver. Do not over-tighten. • Repeat this procedure to attach the other fork cover to the other fork arm.
Label Decoration Attaching the Seat Helpful Hint: The seat can be attached to the frame in any of three positions, depending on the size of your child. Check your child’s fit on the trike by observing the seat to pedal distance, as it is being ridden. If the pedals seem too far away or too close for your child, move the seat up or down. 1 2 3 6 Seat Tabs Seat Retainer 4 7 7 (Label 5 on other side) • Make sure the areas where the labels will be applied are clean and dry.
Removing the Seat Care • Periodically, check the plastic parts and if broken or cracked, dispose of them properly. • Check all fasteners regularly to be sure they are tight. If the fasteners are not tight, tighten them as necessary. • To clean, use a mild soap and water solution and a clean cloth. Rinse clean with water to remove soap residue. Seat Seat Retainer Tab Frame Seat Retainer Tab • Turn the frame on it’s side.